Properly consider your electric meter, check its work independently

It would seem that could happen to metering devices, because they are decades of working flawlessly. In general, you are right, but the counter is a measuring mechanism and how absolutely any device, it can start to work incorrectly. And as a result, you can greatly overpay for the light, and you will agree it is not very nice.

In this article I will tell you how to check the device to account, so as not to pay for a call specialist, especially to cope with this test absolutely anyone.

When you need to check the counter

Below I will give the main signs that point directly to the urgent need to check your accounting unit:

1. If once the payment order for the light you see sharply increased the amount consumed for the light, and you are fine You know that all electrical appliances used in the normal mode and have to pay a much smaller money.

2. The situation is the other way around, you see that the account is dramatically decreased. But do not rub their hands and leave everything to chance. The Management Company or Energosbyt still calculate their losses and then you may have problems, so not to create conflict situation, immediately inform the appropriate better authorities.

3. Or, for example, you recently purchased a house and noticed that your consumption is much higher than the rest of the neighbors, although the number of devices that you use in everyday life is not much different then.

As you can see the reasons for the inspections is not so much, but if even one of them fits your case, you should validate your instrument accounting.

Verifying the connection

The very first thing that you need to check whether it is correct coming and going wire in your accounting device. In case, if the connection is different from the above shown images, you should immediately remove it.

Important. Meters are always sealed with numbered seals, so you do not have the right to disrupt them without the presence of the controller. If you need to alter the installation of the sealed counter, be sure to call the Comptroller and Only in his presence, we reveal the cover, and the removal and installation of seals must be recorded in a special act.

If the wires are connected correctly, then go ahead.

Check counter for self-propelled

To perform this procedure, you must turn off completely after reaching the full load counter. To do this, disable all machines running after allowing the appliance. If there are none, then turn off all electrical appliances from the network, as well as turning off the lights everywhere. After isolating the load we come to the counter and carefully observe its behavior.

If you have a metering device with the disc, then it should do no more than one turnover in 15 minutes.

In case, if you have a counter with a flashing red light, then count how many times it flashes for the same 15 minutes. It should blink only once - two, not more.

If you notice that your hard drive is spinning or eye blinking frequently, it is undeniable reason to refer to the management company or Energosbyt, so that they are thoroughly checked your meters.

As you can see nothing complicated in such checks, but they will allow you to notice the device fault recording and will save you your hard-earned money. Thanks for attention.

Dear Reader, my article was useful and interesting?! Then Put the thumbs up, subscribe to my RSS feed ENERGOFIKSIK and share articles to social services. networks. It is very important to feel your support. After all, it will create even more high-quality materials. If you have any questions or suggestions, here is my email: [email protected]