How easy to propagate fruit trees

If you saw at a friend's beautiful and delicious fruit on the tree, for example, an apple tree, and wanted to imagine the same tree, you can use a simple way. I'll tell you how to do it. Usually this procedure I was doing in the beginning of July.

Step-by-step instruction

1. Find the twig where growth seen this year (it is green). And below it is already lignified part of last year. On the border of this transition, remove all foliage.

2. Remove the ring cortex width of 1 cm at the point of transition to a green part lignified (brown) portion. In this part of the crust will form the future of the new roots of seedlings, which will have all the properties of the parent.

3. If the branch is located close to the ground, it is possible to apply the method of layering propagation. To do this, press it to loosen the soil and press stud, made of wire, covered with soil and moisten. Follow the cuttings watered all summer. The following year, in the spring, you will be ready to transplant the roots.

4. If the ground does not reach the branch, it is necessary to bring the soil to it. At the site of the ring you need to pull a package that does not have the bottom (pre-cut). Counting 3-4 thumb, tie tightly with rope or wire bottom, remove the extra sheets.

5. Pour the wet and loose soil (peat, sand, earth) in the package, distribute the substrate on the package and tie the other, the upper part of the wire.

6. To branch did not break the severity of the package to the ground to secure the other branch.

7. Wrap the newspapers, so that moisture does not evaporate much. All summer long you need to look for a branch, if necessary, moisten the package in the intense heat. After 2 months, the roots should appear.

In autumn best to transplant into a pot, and in spring planted to a permanent place.

Here is a simple method of reproduction of fruit trees there.

Subscribe to the channel "Country life"And put the Like!

Other useful articles can be found here.