How to thin dosochki on the circular saw

Cut the thick board on the thinner may need in many cases. For example for the manufacture of boxes, or other things which require thin dosochki.

But for this casket used dosochki 10 and 6 mm, and I sawed a thicker workpiece manner, which will tell on.

To precisely sawed thick board need to adjust the machine. the saw blade must be at right angles to the table, parallel stop, too.

Parallel guide desirable to make higher to the plane of the board had a solid support.

The photo shows a multifunctional device, which I told here.

Typically sawing boards requires much greater width than the cutting depth of the machine, so they are sawn from two sides.

Cutting depth is first better to put small - about 3 cm. It is easier to cut and less load on the saw.

When propyl made on the one hand, the preform is inverted and sawing on the other hand, pressing the abutment same plane as the first cut.

Next, lift the disc and repeat the same steps.

If the disc departure missing, then rest dopilivat jumper on the machine. If not, you can cut it with a hacksaw manual or take the workpiece does not exceed the maximum width of the two relegation saw blade.

The result is a smooth thin dosochki.

When everything is set up well, after cutting it will be enough to polish the surface of the cut.

Thank you for reading. I will be glad of your support in the form of a husky and a subscription to the channel. And look for other posts on the channel.

Alexander.