Proper chimney brickwork!

Everyone wants his house was cozy, so installing the furnace or fireplace - this is one of the great features add a great atmosphere with the help of the interior.

To date, the chimney - it is one of the main components of any oven. No matter what you are using the oven: cooking, heating or "Russian". In any case, the chimney is needed everywhere and the work and function of the furnace depends on the correct location. Today we will talk about how to properly perform the masonry of the chimney so that it was not necessary to alter and to lose their money spent.

What are the features of masonry chimney?

To begin with, that in itself is quite cheap chimney construction, if we are talking about a sandwich of stainless steel. You can easily and quickly install it on their own, without the help of professionals. But when it comes to the chimney of the brick, then there are several features. Where to start laying?

First of all, the stove is installed a special pipe, it was from her and begins laying. Remember that the construction of the chimney should be started immediately with the beginning of the furnace itself masonry. It is very important. The process itself is similar to the construction of furnace walls. That is, you will also lay out the bricks from the bottom up, keeping the ranks and always horizontal bricks to obtain a clean chimney.

As for the solution, there is required a slightly different composition. Instead of the usual mixture of water and clay added to the solution of cement and sand, or oven ready solution. This is necessary in order to ensure maximum adhesion between bricks, since chimney primarily requires the strength.

If, during the laying of the furnace you use a thick layer of the solution, here I recommend you to apply a minimum layer. The thicker the layer the more likely that a mixture crumble, since the inside of the chimney is high enough temperature.

And, of course, the main condition - it is used for a masonry chimney bricks. Pieces of brick in any case will not work, it needs full bricks, with no cracks and chips. If you ignore the cracks, then later, through them, will be smoke.

conclusion

These rules are a fundamental for the construction of high-quality chimney. Of course, do not forget about the brick, because of its quality depends on the reliability and durability of the chimney. After selecting bricks, carefully note the solution, as stated above, it should consist of several components which impart additional strength to the chimney.

Perhaps this article will be of interest to you:

What is the smoke sauna? I'll tell you how to prepare such a bath!

Features and Tricks masonry stoves

Properties of the heating furnace installation

Optimum width shelf in a bath