Overview of a two-story bath with terrace. finishing steam
In our previous article, I began to consider in detail one of the projects - large and high-quality two-story bath with adjoining terrace.
In the second part of a detailed review, I will touch interior finishing baths, its most important part - the steam room.
This steam room two walls border the street. Despite the good performance of thermal insulation materials, which are made of load-bearing walls and 100 mm insulation of the facade, steam room It was further isolated and insulated.
We primed walls built from arbolita and cement plaster layer was applied with the addition of the polymer fibers. Over the plaster walls, we did a vapor barrier on the crate. After that we have warmed the wall 50 mm of mineral wool Rockwoll Light Batts. The second layer of insulation was ufolgirovan insulation Rockwoll Sauna with sizing seams metallized tape. After this warming through counter crate we spent an additional vapor barrier foil, glue all the joints of metallic duct tape.
According to the same system and insulated ceiling. Then stitched lining the walls and ceiling of the Americas.
The shelves are made from a Cameroonian abashi represented here in two ways: A light and dark, heat-treated.
On the floor is a lattice made of pine boards. two lamps from Himalayan salt located on the sides steam.
The shelves are illuminated, there is a point light in the corner. Also highlighted and portal stove, where the optical fiber was used, the use of which as a backlight due to the high temperature of the furnace itself. Where conventional LEDs would last only once, fiber withstand several years.
The furnace in the steam room - IziStim Gelendzhik in the lining of soapstone, one of which is facing almost 500 kg, which is an incredibly huge array, which is well warmed during preparation, will give off heat during steaming, and then will be well dried after bath use.
It is spacious enough for a pair of oven 18 cubic meters. m., and higher. The furnace is made very reliable, are used stainless steel AISI 430 4.6 mm thick. The volume of the heater was 90 kg, which is an acceptable indicator for the volume of steam at 21 cc. m. As used herein chimney Schiedel.
⠀
The window in the steam room - a wooden German Euro-glazed windows made of alder first category, the Roto fittings, hidden hinges, and the width of profiles 78 mm. On the inner side of the window frame is covered with a special oil for saunas. The window for this steam rooms sufficiently large and allows you to ventilate the area.
Special attention deserves a boiler room in the bath with two boilers - electric and gas. Filtration systems, boiler indirect heat collector nodes of floor heating, radiators two floors. The entire system can be controlled with conventional tablet.
The bath is quite spacious and comfortable washing rooms, where the oblivnye device that you can to pour cold water on themselves after a well napar in the steam room!
Thank you for reading this article until the end. Here are some more of my articles on a similar topic that may be of interest to you:
The house is made of wood. As far as it is eco-friendly?
And would you like a house of Tui?
Siberian cedar