Plastering of walls on beacons

Uneven walls left after putting the house in operation for a long time cause trouble to owners of premises not only for its unaesthetic appearance, but also the lack of ability to perform well and the decoration of the walls properly selected date materials. Plastering of walls on beacons handyman seems difficult, but professional builders know exactly how to do the job quickly and with an excellent end result.

Alignment of the walls by means of overlaying plaster - the most popular and well-known methods. It allows you to quickly get the desired result, but at the same time, do not spend a large amount of labor and money. All you need to work - it is the original rough surface. Also, be sure to also need: solution (cement or lime), a set of tools (the level usually float, trowel, Drill), cord, bucket, gloves and glasses. Installation of plaster beacons It requires an initial visual assessment of the existing wall surface. Try to determine the amount of solution may be necessary, based on the objectives and the prevailing conditions.

Work should start necessarily from the corner. At approximately 30 cm from the applied solution blots. Hence it will be secured a special beacon, as which can be successfully used available slats and profiles. If this is not possible, get in the trade network profile beaconSpecially designed for alignment. Length strictly selected and set by the level of reference points, must be about two meters. In the opposite corner, follow the same preparatory work on plastering walls with lighthouses. The best thing to do is not the main solution, and cement with the addition of sand and plaster.

To further strengthen the cord (fishing line) and exhibiting all of the remaining labels need to screw in screws or hammer dowels at a distance, situated close to the corners. Required to pull the cord tight. Similarly produced and under other marking beacons to be positioned 1 meter apart. In this case it is very convenient to work with a short rule. direct plaster walls on beacons grout It starts with spraying the prepared mixture by trowel at a construction free spaces between the slats installed.

It is important that the solution has the desired consistency. Too wet solution can easily float on the wall, and dry it will be difficult to align. Determine the optimum viscosity will only work in progress. The drying time of the solution on the wall can also vary, depending on whether it is made of any material. Sand-lime brick is not very hygroscopic and, therefore, the imposition of the solution can be carried out simultaneously over large areas. Red brick too quickly absorbs water and require plastering walls with small portions. The most important work - leveling plaster solution rule. The final alignment is performed using a grater.

After finishing plaster walls all beacons carefully removed, and the remaining voids after they are overwritten in one level with the surface. In this quest is completed. As can be seen, the described work does not require prior specific professional skills. They may well be purchased even in the implementation of plastering.

Put Like, if you like the article!
Thank you for reading the article to the end!
Subscribe to my RSS feed to keep out new and interesting articles.