Useful content

Linoleum on the wooden floor: the new life of old boards

click fraud protection

Roll out the coil coating on a new wooden floor under the force of even a schoolboy. Align old "humped" the board is not so easy. Frankly, my first result was so-so. Then he has turned his chips to do everything fast, beautiful, and from the first time.

Choosing materials

Lay linoleum directly on rough boards - money down the drain. Even on expensive high-quality coating in 2-3 years stripes appear on the lower boards. Therefore, the substrate need.

Dub plates floor fiberboard useless. Take the OSB or plywood. If the linoleum with felt lining - plywood, if without it - OSB. It is fundamentally. Why so, I will tell when we come to laying the top layer.

Plates 9 mm thickness is more than enough. If there are local differences of about a centimeter, it is better to increase the thickness to 12 mm. In more complex situations, you should consider replacing or planing boards.

Stela substrate

OSB plates decompose across planks. Usually it is in the width of the room. This distance turns out to close the two sheets.

instagram viewer

The first sheet is placed so that its free edge is in the middle of the board. If the joint reaches the edge of the plate clipped the wall and just displace it. Thanks to this flat and joints are obtained in the same plane.

After laying the first row scan the plate with the free end. If a strongly sagging boards, OSB between them and insert the line (no wedge) lining about 10cm long. Doing so to the middle lining accounted for the joint plates. Fasten it by self-tapping OSB to the floor.

The next series begin to lay vrazbezhku (on another wall), to avoid a long butt across the room. Sheets fasten screws around the perimeter. Then along the middle of the sheet (ideally fall into the beam). When all sheets are stacked, further scrolls to the boards loosely fitting portions.

Cap screws do all flush with the surface. It is convenient to use the bit with limiter (Drywall).

laid linoleum

Roll on roll OSB with felt backing - not for the faint of heart. Worth clings to the rough wood, like Velcro. That is why under the linoleum with felt subbase Stela plywood.

Roll out the roll at the place of, and circumcised him on the perimeter. Perfectly straight walls and corners in practice, does not happen. If the roll is cut in advance is a risk of making a mistake. Between the cover edge and walls make a gap of about a centimeter.

Subject coating until completely straightened folds and waves (3-7 days). Check whether the gap left along the walls. If linoleum comes to them, just cut in front of him. Only then we press the baseboards and furniture set.

If the article was helpful, subscribe to the channel. Best thanks to me - your Like and repost. Thank you for reading!

Ingenious is simple. Useful summer tips and homemade products

Ingenious is simple. Useful summer tips and homemade products

I am showing an interesting, in my opinion, selection of simple, but at the same time ingenious h...

Read More

Here is such a project for a 9x10 house! The best house in our collection

Here is such a project for a 9x10 house! The best house in our collection

Here is a perfectly thought out project of a 9x10 house! It is good, the shape of the house is ab...

Read More

How to easily and quickly propagate peonies in September - a proven method

How to easily and quickly propagate peonies in September - a proven method

Peonies are a true decoration of every garden plot. Incredibly elegant, fragrant, they are wonder...

Read More

Instagram story viewer