"Success" in the aerated concrete masonry. Three blocks of three hours.

Education continues!

Finally, at the second attempt, corner blocks are installed. Now we need to move on. After all the nuances, I encounteredI thought that with the rest of the things go much faster.

But it seems that everything is just beginning ...

The first thing needed to pull a "cord-prichalku" between the blocks.

I took two boards fixed on blocks, and already the cord is attached to these boards.

In this embodiment, it can be harder to pull the cord to avoid sagging, and as closely as possible to put it fit in the corner of the block.

Now, I think it will go quickly and easily.

As I wrote (in this article), I decided to do the masonry in a combined way, using the adhesive for horizontal joints and glue the foam to the vertical.

But in the first row, instead of the adhesive used cement-sand mortar. Therefore, I think, and there were difficulties.

In general, when tonkoshovnoy masonry using adhesive foam blocks installed without further adjustment, those. I put and pressed it.

A laying of the first row in solution

It involves multiple shifts, Etc. pristukivaniya Therefore, the seams I get different.

another problem It was that by exposing each successive block, the previous strayed.

Here I was trying to make the solution thicker, but it did not help: when pressed against the block to the previously set, and you start to sit down with a mallet, then the (previous) starts to move, too.

Therefore, I make out, clean off the foam solution and installed the new.

Generally, the installation of three blocks, I spent the whole evening. But a start :)

I hope it will go further faster ...

Subscribe to the channel and watch my progress :)