Level the surface of masonry. How to eliminate even serious differences?

If I had known that the defects can be eliminated by laying aerocrete such an easy way, the case would go much faster ...

In general, the alignment of the plane under the next row - this is a mandatory process, and no matter how perfect does not seem masonry, it must be done.

Especially because it depends not only on the direct hands and skill, but also on the geometry of the blockWhich may be non-ideal.

As I wrote, When laying the first row, I have often brought down the previous blocks, due to too hard to install and adjust the one sent.

Therefore, I thought that with the float will have to work thoroughly.

Here I used his homemade instrument, a long level and a brush.

Still need tedious wear respirator and goggles desirableBecause the dust is sufficient. Especially if the wind outdoorsAs I had, it would be to fly in all directions.

In fact, the exact thing it can not be called

Of course it can not be done perfectly flat plane. As far as I know, the main thing - is to remove all the "steps" between the blocksWhich can further affect the formation of cracks.

So the main indicator for me was smooth fit level over the entire plane, not only along but also across. And of course, I supervised the horizon.

Most of the time I spent two units that I set above the level of 5 mm. But here I spent a long time.

In general, for all I spent about an hour, and all of my past mistakes have been eliminated.

As a result, I was convinced that everything is interconnected.

• The more accurately put blocks, the less need to rub.
• Conversely, the better you align the surface of the float, the faster and more accurate will be the further clutch.

And it is better to try everywhere... :)