Where adjust trim the covering rail. Simply and usefully.

After the construction I have left a bunch of scraps of the covering rail. Throw a pity, and where to apply for the benefit at once somehow did not come up with.

Of course completely around the trim I did not hang out. I used them as spacers for boards that are bought for various needs, including for wood furniture. But still I would like to attach trim to better advantage.

Finally my hands to them came and I decided to make a stand for hanging the tool.

For the manufacture of the booth, I decided to combine these rails on the type of masonry, especially the way I've already successfully applied in the construction.

To begin, I just laid, existing rail on the table to find out which board I can get.

Then cut off the ends of all the strips at right angles to the joints are tight. Circumcised in their makeshift circular saw.

Next facedown assembled rack. Face down did so to be able to tie the back of the finished cross-bars shield.

Despite the fact that the curl, only two bars at the edges, docking rails on the center to obtain reliable. Each joint on both sides hold the adjacent slats.

In a similar way you can make such cuttings and usual paneling.

The front side of the panel's turned out such (photo above). A final stand came out like this:

Thank you for reading. I will be glad of your support in the form of a husky and a subscription to the channel.

Alexander.

On a note: All the articles of the channel based on materialsmy site -"Joinery"