Collapsed wheel chair? Do not dispose of 5 minutes, and it is like new

The apartment is still littered with the remnants of building materials and tools. But we must move. Otherwise, the repair will never end. The first furniture "for life" became cupboards, desk and office chair. Even the bed had not brought.

According to the classics of the genre at this moment there is an urgent order. I take out my laptop and sit at the table and on the law of meanness in his chair shatters the wheel. In other circumstances I would have thrown out and bought another. But now there is no time, you have to think of something. And from scrap materials and to fix for 5-10 minutes. Not any longer.

Necessity is the mother of invention. Balance water pipe, multiple screws for fixation and glue gun, which his wife always keeps in her box with hendmeydom saved the situation. Minutes, and I'm back "on a horse," I start work.

Wheel after flash repair regularly serves for two years. A few days ago has broken down another. The thought of going to the store for a new longer visit. Again repaired. And even I made a few photos. Suddenly someone come in handy.

Take a piece of polypropylene tubing. I had the rest of 20 mm in diameter. Hacksaw or special scissors cut off from it a ring of 4-7 mm. We do so after installing it is not advocated for the factory edge.

Dress ring at the cracked part. If, like me, fell off a piece, first we catch him glue gun. Once the ring is unlikely to hold on tight. To make the adhesive strength of the gap fill mass.

Before you begin gluing, shrink the cracked part to the factory. To do this, take the screws and are screwed between the polypropylene ring and a broken neck wheel.

In my case, to align to conditionally factory state had to screw the four self-tapping screws. But better if it turns out to do one or two. Then the tube is pressed against one wall, and a wide gap is best filled with glutinous mass.

After all prepared, we warm up the glue gun. If it is regulated, we expose the maximum temperature. The deeper zatechet glue, the better.

Be sure to wait a couple of minutes to complete solidification of glue (It should be white). Unscrew the screws and fill the holes with glue.

Now you're done! We put the wheel back on and sit down in a chair. I hope my experience has been useful to you. If so, is not deprived of his huskies. Repost in social networking is encouraged. Thank you for your attention!