How to make a simple garden bench

The design of which want to offer you tested me in different ways - a small bench, a bench for the bath, a long bench to the table.

Bench can be done quickly. If there is a suitable board or a small bench - cutting boards, then an hour is enough for manufacturing.

Need 4 equal parts on the legs. And three of the same items on side-bar and seat.

It begins with the markup legs. For a small plaque on the bench legs can be length of 200-250 mm. For shops - 450 mm. Seat parts and tsargi length at its discretion choose if one person size may be 300 mm. If this is the shop for a few people, then expect not less than 500 mm in the same place.

Mark up on the legs on both sides of an angle of about 10 degrees. Next to the line marking the one hand putting a square and mark another line so that it appeared on the edge of the board.

Now we saw off marked corners. Saw off can be anything, a hacksaw, a jigsaw, or as I did, on the circular saw.

In the circular saw I turned pusher protractor 10 degrees and is first sawed off angle from the length of the foot. And then sawed off the other corners.

By the way, it is convenient to mark and saw off the corners of one leg, and then use it as a template to mark the rest of the legs.

Next is the assembly begins. First, on the one screw in the middle of the two legs to fasten drawer side on the one hand, stepping back from the edge to the middle of the side-bar on how much centimeters. I did indented 4 cm.

A second pair of legs fasten on the principle of "turning the circuit." The fact that this scheme is for and where it can be applied even see the article: What is the turning circuit

Here legs bolted to one screw turn to the side and fasten the second pair of legs has two self-tapping screws each. Then the first leg is pivoted back bench set as intended and do opening end and at an angle "first" legs to tighten them on the second screw.

The base of the bench is ready. Now it is possible to fasten the seat. To screws not protruded outside, can be pre-drilled holes under them suitable to cap the screw drill or countersink.

It turns solid bench, which can be conveniently applied in the country while collecting berries from the bushes, or used as a stand for other purposes.

If you convenient video format, you can see the process of making the video.

More Articles on the channel:

What can be done from scraps.

Production of Mittlayderu greenhouses.

How to recover from a broken handle of the knife.

Subscribe to the channel, put the Huskies, write comments. I will be glad to communicate.

Alexander.