How to connect the wire without twisting dangerous?
Bthen you may say, butindependent repair of electrical appliances requires special skills and knowledge in the field of electrics. It is only at first glance it seems that the connection of two wires of large diameter - a trifling matter. In fact, few people know how to dock two wires so that their joints are not heated.
FROMoedinit wires without twisting, which is used to heat up when current passes and burn insulation, will help this algorithm:
- 1-
First of all you need to clean up the wire by 1 centimeter, fluff and attach to each other. Strip the wires conveniently using a special device - a stripper. If you do not, use a simple knife.
-2-
After the joining of the ends of the wire they need a little crimp with your fingers to ensure that they are the best fit.
note
We do not twist the wire ends, namely compress the them to stay close to each other in close contact!
-3-
The splice two wires wires need to wrap a thin wire. Winding must keep tightly and evenly across all the contact area between the two wires, the wire should go "vnatyag" that is very tight and close-fitting connection line.
Important:
It is necessary that the wire was slightly thicker than a single "villus" wire to be connected.
-4-
Bared place wires in a junction coat with flux. Then we warm up the soldering iron core and a band of wire. Hot spots are putting the solder to the molten tin fell under the bandage and filled all the voids.