How this thing cut tape from a plastic bottle? show

Yesterday thought I knew, as the easiest way to dissolve the plastic bottle in the tapeBut already I knew that was wrong. Even I wrote an article about super-simple butylkorez. However, the real limit is only now understood the simplicity and immediately want to share his discovery.

It turns out that the bottle is elegantly cut into strips only need a construction knife and a piece of unnecessary plastic, which normally bends. Suitable even large cap on some cans of cream.

The plastic plate bent in half doing through slit in any convenient knife at 4-5 mm below the kink site. This indent will be the width of the ribbons. For wider strips below you can still make additional slots or even produce new discs separately.

Now I thread the blade construction of the knife through a plate and set this tricky thing on the end of the cropped on top or on the bottom of the bottle. Begin to make the knife cutting motion along the edge and try to release the cut edge through plastic overlay. Then simply pull over the end of your fingers caught.

I have a three-liter bottle, and even tried to liter, but there is quite a thin plastic and heavily dented and zazhevyvalo, so threw it.

Thus here and I pulled the bottle in the tape without tearing and it was quite smooth, as evidenced by the shot 4. It turned out even to dissolve most of the bottle where it narrows the cone. Other ways to do so could not, and it's easy!

In general, it is a way to help out wherever urgently need a strong rope or need to hold together some details. If the tape to heat, it is spoiled and the connection will be "dead". Breaking the tape is very difficult, most fingers cut yourself, so go for it!

Evaluate material andsign upCanal.

ANDit is interesting:

Super-simple butylkorez. It is easy to cut PET bottle in a tape

Stuck and puffed punch. Repairs

"And so it will come down." How to insulate a house on the curved foundation