The hammer of the gun. Nozzle for nailing

I am seen a few different tips for driving hammer nailsBut for their manufacturing needs welding, so I suggest another assembly - mechanical, which gather in the garage can be a matter of minutes, if there is need. All that is required is shown in the first picture.

Perhaps the most difficult to find adapter with a punch drill chuckWhich is not always there. I found it in the third point of sale and it costs almost 50 rubles. Shank had made a perforating drill and thread a cartridge drill. Well, screw for fixation to the cartridge, of course. So first adapter is screwed to the cartridge.

The role of the drummer will take over hat trimmed with bolt and wound on the end of the nut. The thicker the bolt and nut, the large nails can score. I decided to try on nails up to 100 mm and it is for them found a bolt.

The nut is wound so that the bolt does not protrude from it, it will protect the drums from sliding off when driving.

Spinning makeshift striker in the cartridge, in looking for some of his body all the way down to the main load at work went to a shoe cartridge, rather than fists. It remains well clamp screw in the cartridge and the entire assembly is ready for operation.

To test I took a thick scrap wood to nail could to drive the entire length. I put the punch in percussion mode without drilling and to the point. Even the first nail to score normally, only a small trace of nuts on the tree remains. His and picture 6 it is seen.

Not to say that the speed of the nailing was stunning, as the punch and not very powerful. But if you take the device more seriously, productivity will increase obviously. So, when the case may have to experiment and see how this idea is viable.

Evaluate material andsign upCanal.

ANDit is interesting:

The simplest column of water in the country

Mysterious broads! And then it burned down an extension cord?

Rough putty slope. What to consider