How to cope with cracks on the walls
Causes the formation of cracks on the walls, lots. For example, such defects can occur due to ground motions, improper construction technology at home, illiterate application of finishing materials. To get rid of the cracks, it is necessary to consider why and on what material it originated. The principal methods of removing such defects.
1. How to get rid of cracks in masonry
This is a dangerous situation that can not ride. To cope with a crack only if the width is not more than 5 mm. Then the crack first embroider, clean from dirt, treated soil. Further, it is filled to the full depth concrete solution using a syringe of special construction.
The main problem is that cracks in masonry rarely retain their original size. You may need to strengthen the overall construction, and otherwise further worsen the defect. To strengthen usually installed metal braces across the damage.
2. How to get rid of cracks on the plaster
This option is much simpler and is not associated with greater dangers. Cracks, affecting only a layer of plaster itself is very easy to fix. They act as in the previous situation: Clean the crack, Soil, sediment little plaster composition. Then it will be overwritten and smooth, so it does not stand out.
But it is necessary to remind the owner that the cracks in the plaster arise during deformation of the entire construction and not only because of the violation of the technology application of a plaster composition. So, the situation must be constantly monitored.
3. How to get rid of cracks in drywall
Noticeable defects on plasterboard panels usually appear with their misuse or due to severe mechanical stress. To deal with a crack, first sheet to be strengthened, causing the reinforced tape. Also shpatljujut defect, then the stopper section carefully rub clean and start finishing.
4. What if the gap through
And finally, the most dangerous situation - the emergence through cracks in the walls. Typically, they are first filled with gravel or broken brick, concrete solution is then shed and proceed to finish. But perhaps soon again be apparent defect, so the presence of the through slits preferably immediately turn to the professionals. Once they identify the real cause of the damage and repair it.