Good glue for wallpaper. What does it mean?

Friends, not about trade marks in question, and the correctness of the preparation of wallpaper paste and its consistency. Today's products for gluing wallpaper are mostly qualitative, but there are exceptions.

Good adhesive or not?

It's the same as asking the owner of the car is good you have a car or bad. In fact it all depends on how you use. The machine we select the best available and enjoy the purchase, is not it? And glue. Most of them are sold in solid cartons nested inside the hermetically sealed package, and this is a measure of care products for customers.

The most inexpensive adhesive samples were packed in conventional transparent plastic bags, which, under the weight slozhivayutsya each other gradually and eventually slipping in dry lumps. Such goods lead to a working condition is very difficult, especially if the work is done in the short term, since such a substrate should soak up the day, and even more. If the glue from the usual soft transparent package fresh and diluted with water as recommended in the table on the package, even with the problems it usually does not happen.

How to be diluted with water

Hope on intuition may fail, since the compositions are varied and, after the addition of the same volume of water are different consistency, which causes sometimes, including masters, add a thick glue more fluid than necessary. But if you are committed to quality, you can not do this, can not and should not be again! Many types of wallpaper are classified as heavy, so properly cooked glutinous solution on their long wall will not stop, and then the problems could not be avoided.

Always look at the table of any package, no matter what language, shows how many liters of water it is designed and do not risk adding more so as a mass less thick consistency is not as sticky and can not cope with the task: Wallpaper pop, diverge at the seams, and then completely exfoliate. More on the box it is usually referred to as dilute glue for priming the walls, which should also be trusted and do not try to at least somehow save.

How to beat the glue

Before backfilling powder cut one corner of the bag, and then starting stirring rod prepared in the bucket corresponding water temperature. Water should disperse as long as there was a small crater in the middle of the tank. It is necessary to support up to the end of the breeding process. Pour the glue necessary to uniformly and continuously, but not in the center of the container, and in the middle of moving in a circle volume. So the powder and stick to the walls will not, and will not get off in a lump. But if you get in the way too slow, it is likely that the last portion will turn into lumps as saturated with glue water gradually stops and powder fray at one place.

Let it happen, do not worry, 30-60 lumps mine will disappear, and the bucket is completely smooth. When done correctly, adhering to the blades begin within 3-5 minutes after the dilution. Sometimes the manufacturer recommends to wait 15 minutes, but it's not much.

Also learn how to wallpaper glue without errors and expand the understanding of the topic.

If you found these tips are practical, mark the material as a favorite, and subscribe to the channel. It will still be many important nuances of construction and finishing.