"And so it will come down." How to insulate a house on the curved foundation

"You're our only first row of foam Poquelin, and then we ourselves will do" - people such request is carried out in the last few days. Just like everything, but in fact in 5 minutes at the site, it became clear that to be oh-oh-oh-oh-a very great confusion. House small, 7h9 m, but tinker had 4 days.

The fact that the foundation is poured, and crooked places protrudes beyond the plane of the wall by 5-7 cm, which is why just go and stick the foam is impossible, and it was necessary to first cut its projection repeating shape.

In addition, the height of the basement from the ground everywhere different from 15 to 40 cm, which means that each sheet first had to trim the height and then cut to the base curvature. Good that foam sheets 100 mmAs well as a less thick insulation in such a way to do anything would have happened.

On the first day of work before gluing on the perimeter of attached U-shaped galvanized profile 100 mm of foam width. I mount it on the dowel-nails in increments of 30-35 cm. Edge profiles wrung softwood ..

Since it was necessary to insulate the entire basement and the projecting part of the foundation, metal profile on the horizon is not exhibited, and just put it on the ground and poprikruchival as is. Since repeated line bulging profile foundation, it had to be cut later grinder flush with bonded foam sheets.

Foam trimmed and cut with a knife and fine teeth blades for wood.

Due to the unevenness of adhesive consumption during gluing sheets increased in half, i.e. instead of one sheet bag 5-6 adhesive paste mixture managed only 3-4 leaves. By spreading with a notched trowel there has not been, and had to apply a mixture of thick roller (photo 3).

Typically nanoshu adhesive so that the adhesive bead formed on the perimeter of a closed line, and in the middle of the sheet - lyapuhi or smear notched trowel. Thus each sheet of foam insulation forms an independent circuit or to walk wearing air.

On picture 6 clearly shows how the curve foundation under foam. Here the protruding part of the profile and then had to cut off the grinder. Profile needed as a kind of protection from the bottom. Thanks to him, the rodents will not be able to get under the foam and can not sharpen it.

The top edge of the foam is level, The hosts were able to continue to yourself to do what they want and how they want. Then another will have to mount a mushroom-shaped anchors for fixation of 5-6 pieces of foam. on the list, but that's not my problem.

He offered to glue the foam from the top line of the cap, and then align the bottom already after casting a blind area, but there is not approved, that had seemed to. But it turned out like a good idea. Now, here I wait, then what to say. Somehow, it seems that the end is not yet.

Evaluate material andsign upCanal.

ANDit is interesting:

How to buy a new low-cost punch

Soldering pipes homemade soldering iron. Powered by gas and fire

Aunt froze: Box of another radiator and "Tashkent"