Prevent erase laminate chair wheels
Since I do not use a chair to the computer rug on the floor area under the wheels began to deteriorate laminate. Although he 32 class, which is normal for an apartment that did not stop the wheels for a couple of years leave quite visible traces. To the problem was aggravated, he had to spend a little modernization chair.
In the beginning I was going to stick on the wheel thin skin, but then refused because of the wheels with a minimum gap is plastic casing, because of what put him under such protection is problematic. That attracted the rescue think that? Correctly - saving insulation tape, Not blue, and black. Specially bought a new skein.
With wheels previously wiped with a damp sponge and dust couple of minutes they dry.
While duct tape slightly wider wheels, that did not stop them neatly wound on multiple layers. At the wheel gets pasted 3-4 turns, as if the more she began to rub against the protective cover.
Glue a little better in the stretch, then to when riding on the floor adhesive tape does not stretch and flew off. Use scissors to cut the ribbon tried in the place where the first round began.
The speaker on the inside edge of the wheel like electrical tape first cut with a knife, but then changed his mind and just buckled up tape and so left. Such inversion either from above or from the side of the guard is absolutely not visible.
Insulating tape color blends with the color of plastic and nothing betrays its presence. Thanks to this flexible insulation chair not only ceased to abrade the floor, but also in the movement began to publish less noise. Even if the adhesive tape in a time selling, it is not difficult to replace.
All 5 wheelsets lasted approximately half of the skein.
Immediately I noticed that the wheels have started to collect the dust and they are in contrast to the gray foundations, seen it, but it's not terrible. In general, the effect of improving the content.
Evaluate material andsign upCanal.
ANDit is interesting:
How do I know this disk for a saw or grinder?
The simplest clamp for 5-10 minutes. five ways
How to unscrew the nut without a key. We need a couple of corners