Pasting of walls film. Procedure
Before you implement the pasting wall wallpaper, you need to thoroughly prepare the surface, as if before a quality painting. The walls are recommended to thoroughly clean the old finish, zashpatlevat synthetic filler. Prior to final painting, the walls are polished using sandpaper (number 20).
Before you start papering the walls of the film, you need to draw a line on the wall, which will be glued to the film.
You can then go to the film cutting, it is done with special knives. Each strip is needed to mark the back of the number, in order to know what the next piece of glue.
Pasting of walls wrap cloth
If the film is carried pasting wall cloth, the adhesive is used "Bustilat". Apply it with a roller or brush. Immediately after the walls are smeared with glue, they should start to put film Overlap 3 cm. The film is smoothed with a special plastic spatula. Thereafter pasted portion is let stand for 4 hours, and after it is possible to start prirezki joints using a metal line. After cutting the adhesive film edge lubricated and are connected end to end, and the excess adhesive is removed with a dry cloth.
What should not be allowed at pasting wall film
Implementing pasting on their own, often formed on the surface bubbles, spots of glue, swelling, which allow extremely prohibited. You also can not glue film without adhering to the pattern. When cutting each strip should first carefully align the drawing strip, and then measure the desired length.
Pasting of walls wrap cloth
Pasting of walls on the basis of tissue film is carried out on the same principle as in the previous case. Preparing the wall for painting is carried out in exactly the same way. This material is used for walls in the administrative offices.
The only difference lies in the fact that such film is glued 6% solution of CMC glue. Before operating the glue necessary to stir well, and check the viscosity, which should be in the range of 25-30.
Before pasting is effected wall film of this kind, it is recommended to stand overnight at room temperature. Only after that the roll can spin to carry it cuts into pieces. The cut pieces need to be folded on each other face down. Stacked to survive until it is completely straighten. The film is glued from the top down.
Pasting of walls film
Each canvas is glued overlapping. And the edges are not lubricated by the adhesive to the end of all the works of their crop. In the corner of the film are glued overlap, to avoid formation of the gap angle of the center if it is uneven. Excess adhesive is removed with a dry cloth or sponge.
Pasting the walls of self-adhesive film
Pasting the walls of self-adhesive film is usually carried out in kitchens, bathrooms, as well as administrative buildings. Before you begin pasting the walls need to be carefully prepared. You can then unroll a roll and cut it into cloth. This kind of film is glued by hand from top to bottom. Remove the adhesive tape is recommended gradually to avoid its adhesion. The film is smoothed with a soft brush from the center to the edges. If the surface of the air bubbles are formed, they must be pierced with a needle and let out the air, and then carefully smooth film. When working with such material must be very careful, because it sticks together very quickly.
Now you know how the film pasting the walls of various kinds.