Almost "Eureka." What did it cost to replace the valve in the farmhouse
a situation such: Crane 80s, is responsible for the water supply to the house, bush in it tricky to the same twisted, can not be replaced. Bottom valve is connected through welded to the pipe fitting of the hose tractor hydraulics T-150, which is "on hot" inserted in plastic pipe Soviet times. Well, the top part of the crane Polypropylene MPH.
It seems that everything is clear, but the story happened in the villageWhere the local store to find something suitable - a miracle.
dismantling
First decided to remove the faucet and then look for everything you need on the basis of what will be saved.
Here and at length it was necessary to guess the details and pick up a new connection for the transition from the hose to the tap. We went with a host of local and hozmage as they could, otovarilis. We found this:
- watering summer shower with flag bronze faucet;
- bronze sleeve 1/2 inch;
- adapter with 1/2 to 3/4 of explosives;
- HP threaded fitting with thread 3/4;
- PTFE seal.
Given somewhere 300 rubles for all. Best combination, alas, did not work. Leica unscrewed for other purposes, and the tube and the tap of it useful. Items are arranged in such a sequence as to Figure 3.
Collect the entire block had in advance, as mounted on the tubes prevented other pipes. The pipe extending from the bottom, I had a little trim the size of the entire structure. Then I had to fasten the entire assembly through the coupling to the MPH. And even before the installation is forced to had to temporarily remove the check mark from the crane, since prevented the installation. On picture 4 whatlower visible intermediate result.
Nezhdanchik
As it turned out when checking, set last cracked clutch in length, and there was nothing to replace, as the shop is already closed. Its wall was quite thin. It had nearly an hour to dig into the barn, looking for at least some substitution. I managed to find an old steel sleeve with nedorezanny thread that is defective. But even that did not stop. Worthless piece sleeve cut grinder, normal - set to replace.
And we remember that we need 1-2 suitable for diameter of the clamp to tighten the pipe fitting. They also barely dug.
Result
Work foolish, but took half a day, and all because that was done spontaneously. So once again I proved that even in simple matters definitely need thoughtful planning, otherwise hassle guarantee. Well, at least the end of good, everything was in place and there is no leakage. Yes, the friend still need to be helped, and now home.
Evaluate material andsign upCanal.
ANDit is interesting:
Flows tank. Eliminate two possible causes of the inlet
That's stainless steel! Rusted sink and dropped the siphon. Repair for 30 minutes
Maybe the oil was? Replacing the cartridge in the filter in the kitchen at 6 months