Eliminated the tiles on the wall

I like my work a constant novelty. With yet unresolved problems with ventilation switch temporarily to perekleivanie breakaway tiles. The most amusing in this case - the cause of the incident.

Tiles with working in the kitchen wall began to crumble in the middle, just above the gas stove. At 95% sure that it is in it's the reason, or rather in its inappropriate use. The remaining 5% is left to vibrations from lower repair - shop did on the 1st floor

An old stove in the winter tenants include heating, as well as it does not have a vertical panel the wall portion, the tiles on the wall and heated due to thermal expansion in the end itself and squeezed fallen off. Fortunately, that broke only one thing.

it took

All lagged behind tile teased spatula removed, cleaned well, that there is no protruding mounds of the dried adhesive, remove old grout and foundation infiltrated primer Ceresit CT 17.

Naturally we need and a good glue, not only looked for loose tile adhesive, which in bags, and so to be able to work with a thin layer of the old base

(Photo 2). I bought a jar on 1.5 kg per 250 rubles.

As you can see by the pictures, tile disappeared without glue, which created the foundation. To reduce the remaining quietly on the wall tiles have disappeared, the adhesive layer should be minimal. Nanoshu its dot.

According to the instructions to the adhesive, the tiles can be adjusted on a plane for 15-20 minutes and the adhesion at the adhesive is necessary, therefore, I decided to from underneath the tile support rail does not put.

First glued entire bottom row of crosses using 1.5 mm. Stove down is not crawled. I leave it for 20 minutes, until the glue to grab a bit and then went on.

The bank with the adhesive was a mini-toothed trowel, which leveled material. Just dealt a 12-15 points on the tile. After completion of gluing bank remained approximately 1/3. So the 1.5 sq. m tiles took about 1 kg.

The second and third rows of the bottom row of your weight or slightly shifted. When he realized that the adhesive enough, began to apply a little more. 1.5 hours with the tile issue was resolved, I hope for many years to come.

It remains to choose the grout and bring it to completion and do it today until the end of the day. Complete drying tile adhesive used on an absorbent base - 24 hours.

Evaluate material andsign upCanal.

ANDit is interesting:

Why put a flexible liner made of PVC instead of stainless steel

Surprise with ventilation. I was not me, and not my cow

Caulking without sanding. My rate in finishing