I put the mixer. It seems to be easy, but there are nuances

Here brass mixture of Chinese origin. I took the average price, but the home flexibles still did not put, replaced the universal hose with red and blue markings.

blog readers may remember the article "Hose, which should throw"Where I briefly told why I prefer not to put a complete liner with low-cost mixers. This is exactly similar case, although the hoses in general, and not bad, but nevertheless... And screw the normal factory pipes in deep-set in the thread body is not easy (Photo 2a).

Collect all in a heap can be intuitive, but important assembly sequenceSince due to the unnecessary manipulation of something scratched or worse, broken.

I am going on this order

Initially, I find The thin sealing rubber ring and push it into the groove bottom on the mixer body (Photo 2a). There it sits firmly, but sometimes falls, then it is better to put it after screwing the first flexible hose, but not later.

Now hoses. As can be seen on shot 2b, their nipples are different, that is made specifically for the convenience of tightening.

The first twist tube with a short nipple and tighten the spanner on the hexagon 10 on the nipple. More interesting!

If you just screw in the second pipe, the two together, they will not pass through the mounting hole in the sink. Therefore it is necessary to cheat.

In this set there are still decorative ring-stand also with an annular seal. I put them on the screwed hose and pull it down through the hole washbasin.

Next, put on the bottom to set the hose yellow tube with a threaded nut and seal on it(Visible in picture 3).

And only now tolerate the bottom of the second tube and through the above it is screwed into the mixer as well as the first. In the end, everything should look something like the picture 3.

In continuation, holding the top of the wash basin mixer with one hand, is screwed in and tightened up to the stop tube yellow.

To the mixer was held, is to tighten the big nut on a yellow nozzle available-key. If the key is not present, it is necessary to try to tighten by hand, so, too bad it turns out.

Also, before tightening the nuts must be correctly set ring-stand under basin mixer.

Without any material for sealing I wind the hose nut on the cranes and only slightly tightens their key. If you drag, tap end selling rubber or silicone gasket inside the nut that makes be very careful.

Nuts, if necessary, can pull and after the supply of water.

Here it is, the shining handsome, already in place and fully operational. I turn on the water, my hands for dinner!

Evaluate material andsign upCanal.

ANDit is interesting:

So much mold in the apartment had not yet seen. And the reason is a breeze

Semicircular cornice for blinds the soul. already installed

I turn the key in the old drill down