How to securely seal the crack under the paint and wallpaper. Step 3. Painting

This is the third and final article in the series about the closing of cracks, which shows how to perform painting the repaired surface.

Since the letters will not show particular painting, I prepared a little video about that at the bottom of the article. Also, there are references to earlier publication series.

I will note only a few points that determine the final quality.

Surface

Before painting any burrs and irregularities tidy up first with a spatula, and then sand mesh (or paper) with grain 220-240. The grid can be used without grinding boards, just not much to push, to avoid streaks. take Velor cushion 30 cm it is convenient to me. If you use a roller with a long nap, it is likely to remain a more coarse irregularities, especially in the colored areas.

Dust rented, but additionally the wall before painting is no longer the ground.

Paint

Previously painted wall acrylic waterproof paintThen this should be buying and that the surface was smooth. And keep in mind that coincided invoice, which is matte and glossy.

See, when the wall does not take a matte gloss paint, and then part of the room will not shine the way.

Short of the

Nanoshu paint in several layers, usually 2-3. It all depends on harboring a material's abilityWhat's worth asking the seller. Paint with very good coating will block a different color putty 2 times. And with luck temperature, humidity, and the quality of the paint surface it can be applied in a couple of hours.

If you apply early, it is likely that the uncured top layer of the peel roller and still have to wait for the complete drying of the first layer, and paint again.

In this series I will finish for coloring, just leave links, as promised:

Step 1. Training

Step 2. Caulking

Evaluate material andsign upCanal.

And it is interesting:

The simplest remover of isolation from wires of clothespins

3 a method for replacing a mosquito net pens. Simply nowhere!