How to clean a laptop from dust. Master OK
I welcome you to the channel! Today is a holiday, so we can pay some attention to the home technology. I had already written as I cleaned the old PC.
Consider how clean from dust Lenovo laptop, Using a screwdriver, knife and cosmetic brush. Talking exclusively about personal experience, which is exactly what you can optimize something, so in the comments suggests their achievements.
In this way, this laptop has purged the 6th or 7th time. I do it about once every 8-10 months and it helps to prolong his life.
How do I know that it's time to clean? It's simple - if the machine starts to warm up more than usual and with a radiator grille constantly talking hot air, it is time!
Getting Started
To access oblipshemu dust cooler, need only remove the back cover and the keyboard. First disconnect all unnecessary, folding screen and turn the unit upside down, the bed under him something soft.
1. Remove the back cover, it is necessary, as it has under the screw securing the keyboard. With the lid closed to clean the computer will not work. Unscrew the screw 2 in red.
2. After removing the cover unscrew the screw 3, which is drawn near the keyboard. I have them, too, are marked by circles. Two screws are located on top of the body (Photo 3a)And third - the lid, approximately in the middle. He also marked with a keyboard (Photo 3b).
3. On this bottom all. Next, turn over the notebook to its normal position, open the cover of the monitor and try to remove the keyboard. We will need a knife (suitable spatula and 3-5 cm wide). There need be careful not to scratch the bezel and damage the keyboard loop. Poddevat previously otkruchennuyu keyboard on top (4a pictures), pass a knifethroughout the length and lifts her (Photo 4b) so as not to take off a train. We find a black plume clamp, release its raising up (Photo 4c) and take out the loop. All keyboard can be postponed and then separately shake out her garbage.
4. When the keyboard is removed (Photo 5a) and back cover (Picture 5b) with both sides visible dusty cooler. And it should be brushed. I use this for a soft cosmetic brush and along the way the fan is blown. I prefer to clean the underside of the monitor with the lid open. To cooler during cleaning is not cool, it is possible to hold the bottom of the fingers, and then scroll down a bit and squeeze again.
5. An important step of cleaning - purging lattice (Photo 6). First, it is desirable to blow it from the inside to the bulk of the debris flew outward and not inward laptop. If you look at the light, all the gaps between the plates of the radiator should be reviewed. Having a handy brush with a long nap, you can work on the radiator it.
When the dust is finished proceed to the assembly. Usually all it takes me about 30 minutes. The first time, however, clean longer. After cleaning, the computer runs quietly and is not heated. This article was written on it immediately after cleaning - it means everything is OK!
The short video shows a cleaning brush and flushing.
Put your article assessment, and share your thoughts in the comments. Subscribe per channel, so as not to miss out on something new and useful!
Read more:
Wallpaper - "Wah!", And the walls - the fear! What came of it? Master OK
Gross mistake when installing the hose. Master OK
remote control buttons do not work? 15 minutes and everything is OK!
Accurate trimming of wallpaper on the ceiling. Master OK