Make a wall organizer for a tool to quickly and easily

Hello everyone Kulibin, Mhalych you again with another interesting homebrew twig. Today we will do a wall organizer for tools of the material at hand. I believe that such an organizer should be in every rukstogo man. It's simple to ugliness and made just for 15-20 minutes.

As always, I warn you, it is not necessary to strictly follow the specified size and then perform direct one to one. Fasting is intended solely for feeding the idea of, well, an implementation detail already choose to fit your needs.

Take an ordinary piece of chipboard unnecessary. This may be a piece of OSB, MDF, or any other timber. The main thing that he had just such an elongated shape as in the photo.

Then depart from each edge of 2-3 cm and making notes with a pencil or marker.

Tagging need to spend two parallel lines along the entire length of the CPD. They will serve as a guide for the installation of fasteners that was nice and smooth.

Next, mark up the cross-line, I have them marked with yellow and are a site of attachment for screwdrivers.

For fixing of screwdrivers will use here are plastic holders for cables. Immediately look to their inner dimension corresponds to the diameter of the tip screwdriver. If there is no suitable, just go to the market and buy these bindings of different sizes, they cost half a penny per bag, that is not expensive.

For holding tools with handles apply here are plastic plugs. Dowel must have a hat, it is sure that the tool is kept in its place.

For fastening of the universal two-way screwdriver with interchangeable nozzles use the mount for plastic pipes. Also choose the size of your specific instrument.

We start the assembly organizer and the first thing we fix mounting screwdriver. The mount for the cables you need to rearrange the stud to mount to fix on chipboard semicircle outside. As shown in the photo.

Hammering them into our DSP so that the center half-ring located on the conditional axis of screwdriver attachment. Do as pictured below.

Plastic anchors are too long, we are not needed, so the bite off the excess wire cutters or a knife cut the stationery.

Anchoring dowels with screws directly beneath the top line. You can make and the center of the board, depending on which tool will go to hang.

Now fasten a screw holder for universal screwdriver. Fastened below the upper tangent line. So it will be more aesthetically pleasing look.

Now ready organizer is fixed on the wall in any convenient place for you. If you have any of these organizers is more, it is better to start the nail on the wall, two vertical rails, and already on them to strengthen your organizers. This is not to do a bunch of holes in the wall for each organizer.

Well now the final moment. Install tools to places provided for them. The first thing a screwdriver, then pasatizhi, pliers, a screwdriver and two-way as in the photo below.

Well that's all, the organizer is ready, use and enjoy.

Use Practice has shown that plastic fasteners for screwdrivers to fix better than their native nails, and it is better to put on the screws too. Nails in bad chipboard hold and will soon begin to fall.

That's all. Diy thank all who have supported the author and penny channel. It's really motivating. Who wants to participate in the further development, I suggest the form below.

On all this, all the good and peace.

I recommend to look:

• Lathe for wood with their hands
• How to quickly clean the tile joints screwdriver
• Vegetable chopper with his own hands