How to surprise guests at the table the original holder for glasses! 4 simple steps

wish make a splash, Meeting colleagues with a good bottle of sparkling wine? Or to impress friends and family, giving banal chic filing hop on the table! No problem!

Good afternoon dear friends!

Of course, a treat in itself is attractive and appetizing. But its presentation in an unusual form, will only increase the anticipation of tasty process. So today I am prepared and step by step instructions that will help you for some 45 minutes make a unique holder for glasses.

In this case, it is not difficult to do!

1.What do you need? In fact, almost anything - a piece of plywood (in our case, 25x25 cm), sandpaper, paint or stain, drill, jigsaw, 32-38 mm crown wood, drill 10 mm, pencil and your time!

2.preparation of the blank. Draw a square of 25x25 cm and make a drawing of the planned cut. This will be the main form, and from which you will be working on. Sand the edges with sandpaper to remove burrs and irregularities.

At the same time and go over the entire surface on both sides, it's not always a sheet of plywood has a flawless look.

3.preform markup. Draw two lines diagonally. With the correct metering earlier, you should have four identical triangles. Then, in the middle, at the intersection of the diagonals, drill hole by means of the crown of the tree (diameter must fit the neck of the bottle). After all, this place is designed just for him.

Then, on each of the four lines, using tape measure or ruler, make measurements at ten centimeters from the edge. And put a pencil mark.

4.Drilling holes and "grooves". Drill all four labels drill 10 mm. and draw two lines parallel to the main of them. Start them will have holes, and the final point on the edge of the base.

Then, using the jigsaw cut slots in the finished layout with maximum precision and accuracy.

5.masterstroke. Again grind almost finished stand, paying more attention to saw cut locations. Further, it can be covered with lacquer (stain) or left in its natural form. Do as you see fit! And a unique holder for glasses ready! It remains to fix the base glasses of the legs, leaving the middle hole for 'culprit' all your creative process.

By the way, "holder" can give quite any form (rectangular, round, oval ...). Cut slots for two or more glasses. Painted in bright, "tasty" colors. In general, the experiment! I'm sure you understand the idea!

Previously published materials:

Who says that cheap or old furniture may not be the highlight of your interior. 5 cool DIY ideas

Why not get rid of the old grandmother's cupboard. 6 practical solutions

IF YOU these tips will come in handy, or liked the article, be sure to click "THUMBS UP" OR SUBSCRIBEON CHANNEL !!

Thank you for your attention and I will be glad your comments!