Doing tubular crowbar, which he is comfortable. My opinion

This crowbar can be done in two ways, in the first case using a metal rod with a diameter of 16 mm, and the second finished pipe of the same diameter.

The first method is time consuming

In doing rod hole drill 10 mm and respectively receive the handset, then it grinder disk metal cut angle and the same grind one plane.

method two

Take a finished tube bending, as wedge cut out and worn down. This method is the easiest and fastest allows any of the pipes do crowbar. The downside of it is that a curved hollow tube less robust than the rod.

Where did the idea

The fact that the tool, which is described in the first version, I already had, I'm his only slightly corrected drill and angle grinders.

Presumably this is the product of the Soviet Chelyabinsk Engineering Plant trailers, which cost at the time of 95 cents. I was surprised by the tubular structure, which met for the first time, I had never seen such a performance.

What it is convenient

It is able to maximally close to the surface to catch nail head for removal, It is no classical counterpart will not happen again. In the photo above for a demonstration, I used a nail for nailing architraves, He has virtually no capBut the tool did a great job with it, that's it.

Total

To create such a product, you can choose two options, make it out of the tube or solid rod by bending the end of a wedge to desired angle.

subscribe to the channel, Share the publication with your friends, like, put the Like. Your home renovation.