How to embed a gas bar countertop
Built-in appliances ceased to surprise the Russian consumer and has become a traditional part of a modern apartment. According to statistics, most often in cabinets built hobs and ovens.
If in the case of electrical appliances issue is resolved in favor of the installation (because of the high degree of security), the integration of the gas panel in the table top - is complicated, and requires a preliminary conformity assessment conditions.
For example, in old houses the average wear rate of gas pipes - 69-85%. Such structures connect plate is allowed only after the restoration or replacement pipe. After all, the wrong installation of the equipment threatens leakage of methane and fire.
Location
Gas panel will not work to build in the countertop next to the refrigerator, as this neighborhood is contraindicated. Cause: overheating and reduced motor life (responds to the increase in temperature, increases the power).
Precautions need to do it over the dishwasher and washing machine.
Should remain free access to the pipes, taps and connecting spike (to check for leaks and prompt repair service).
I drank a recess in the worktop
Most often in the installation instructions are specified dimensions of the slit. If data are not available, the panel is installed on the selected location, encircled the perimeter of the handle.
From a place inside the boundaries drawn indented another 1-1.5 cm (measured on the panel the difference between the embedded base and the worktop).
Masking tape is pasted on the perimeter of the recess so as not to scratch the surface. We draw on the scotch cutting line panel size.
From the front edge of the table should not be smaller than 5 cm., Otherwise, then it can go wrong place.
Making the 4 corners of the drawn line holes 10 mm. See (scroll) pictured above. Then, a jigsaw cut hole boundaries. Spila polished with sandpaper.
Processing cut
Process the slices generously countertops PVA.
Better suited moisture resistant PVA index 3D.
Before building the worktop panel border drunk after it is important to treat mixtures sealed (optionally seal tape).
Stuck on the slices (after drying PVA) Of the reflector aluminum tape. This is optional, but will not be worse.
Since the plate is securely fastened and sealed by the impact of litter and water.
Installation and Connection
Mount the fixing plates that were in the package. Then the gas panel in the table top is inserted and tightly secured. To connect to the gas pipeline will need a connecting hose (metal, rubber bellows).
It closes the gas supply valve. By means of the movable tool plate connected to the hose pipe. Seam sealing tape is wound protective (FUM).
At the last stage, it is important to check the tightness of the joint, the absence of methane leakage, the work of the burners.
channel RemontDom: Subscription and huskies are welcome. Thanks!