How to easily transform an ordinary bedside table in a unique element of the interior. reveals the secrets

Good afternoon dear friends!

Why throw away and buy new when you can repair, restore, decorate the old or ordinary? After all, these pieces of furniture, with a creative approach can bring an unforgettable and unique touch to your interior.

It remains only to buy a few materials, highlight a bit of your precious time to roll up our sleeves and turn previously useless or bored with the furniture in the stunning interior element, perfect fit into your bedroom. To this end, today I prepared step by step instructionsThat will help you in this wonderful event.

Just make a reservation, it is not necessary to dwell and dwell only on the implementation of the ideas mentioned below, as you no one stops to "turn on" the imagination and replace the handle, apply sophisticated pattern on the legs, use a different textiles with Decoupage…

1.What do you need? Little! Fabric glue for decoupage and a bedside table itself. A tool: drill, tape measure, scissors, stapler, pencil, marker and brush. Oh, I almost forgot. 3:00 free time! And yet!

2.Preparing tables. With the screwdriver, remove the legs from the bottom and refurbish the corners, the front of the tables if there are chips, deep scratches and other abrasions. Since after decoupage them will be very problematic to fix.

In this case, the tabletop, low tables and its sidewall can not touch because they are hidden cloth.

3.Working with fabric. I shall warn before buying light fabric for decoupage remove measurements, so that the material was enough to wrap it around the table, plus 15 cm (edges, folds and faults).

Next, measure the width of the table and put the check marks on the fabric. Cut a piece of fabric 5 cm wider than the width of the table surface to achieve ideal edges.

4.Alignment and "sticking". Turn the nightstand and using a marker and mark the center of the table roulette, which will serve as a "starting point" for the fabric.

Then attach the cut-out piece of cloth to that line, align the edges and with a stapler, attach it.

5.Decoupage. It is time to apply adhesive to decoupage (Mod Podge) for the remainder of the lower side and partially on Attached tissue stapler. Thereafter wrap material around tables to the central line.

Make sure that the edge of the material taut and fit snugly to the corners.

6.The final stage. After the previous step, you will most likely remain superfluous matter that needs to be cut off, leaving only 5 cm to the fold. Next, fold the fabric so that it was almost joint to joint with attached edge, apply adhesive and attach it with a stapler.

It only remains to wait for the glue to dry and re-fasten the legs to the base tables. EVERYTHING!

Previously published materials:

Who says that cheap or old furniture may not be the highlight of your interior. 5 cool DIY ideas

How to make the hallway with his hands. 7 "simple" steps and 24 hours

IF YOU these tips will come in handy, or liked the article, be sure to click "THUMBS UP" OR SUBSCRIBEON CHANNEL !!

Thank you for your attention and I will be glad your comments!