Finished masonry fence posts from "Washed Concrete" blocks
As he wrote in previous article on this subject, in the last year when the cable assembly is not divined its length - the pillars were higher than metal pipe. It was necessary to build a cable for decorative lighting of the fence.
I bought:
- cable-VVG 2x1.5 Png TU - 5m. The load will be on the pole 10W, use Gostovskaya does not make sense.
- a plastic corrugated pipe for outdoor use (black), 16 mm diameter - 10 m (of smaller length was not). Gray corrugation from ultraviolet crumbles. It is for interior applications only.
Done such segments.
Climbing a ladder braided wiring, propaival and isolated compounds.
Connection corrugations wrapped with insulating tape
Established last ten blocks on each post. They were working the most. Because in their lower part it had to cut a rectangular slot bars of the fence. Then, as usual, set the horizontal plane and vertically to cover and seams.
Thereafter, the top of the block to cut a groove in the cable exit outside corrugation
There was a final part in the masonry pillars - installation of covers. When pouring the concrete lids I installed fittings segment. He comes to the solution of the indoor unit and the filling lid locks securely on the pole. Many of them are fixed to the mounting foam. Concrete bred in the sand. With pebble filling valves will not enter into such a concrete.
Finished installation at dusk. Photos made on the following day.
Smeared seams under the covers (standard procedure when installing blocks each layer) and washed with water seams. Welds fused the texture blocks.
To be continued…
Subscribe per channel, introducing it in the browser bookmarks. There is a lot of useful information and interesting articles.