Fence of the decorative blocks, and metalloshtaketnika. Grouting in blocks

After the next layer composing blocks which are fixed to the crossbar metalloshtatketnika, blocks laid above - it is necessary to cover the joints between beams in the exit field. It is necessary that the poles would look monolithic and that would be when filling out a solution - do not flowed out of the concrete joints.

That would not stain painted beams - wrapped them with stretch film.

Units always check the horizontal and vertical level. If necessary, first enclose the solution on one of the faces, check again and only then rub clean seams. Immediately they wash foam sponge with water.

The solution was drained from the texture unit, since in the sand there is fine gravel

All have not bought a drill. Sometimes solution kneaded screwdriver. For jointing the blocks 11 need 1/3 solution buckets

In every two mounted unit is poured inside the concrete. Two blocks away concrete bucket

In operation, the accumulated debris and concrete baby. Knead them into the mixer and poured into a column. Part of the large pieces of concrete rubble is placed inside the column after casting solution.

Special load inside of the column is not experiencing. Therefore, this kind of fight Crushed concrete savings.

Poles are slowly but grow up

The exact amount of concrete in the forms can not be calculated by pouring units. I do with a small margin. The excess is poured into molds for tiles with paper impregnated concrete setting retarder.

Tile will later on monolithic track

Previous Section

Read more: A fence made of blocks "Washed concrete" and metalloshtaketnika their own. Results of the beginning of August

Subscribe per channel, introducing it in the browser bookmarks. There is a lot of useful information and interesting articles.