Fence of blocks "Washed Concrete". The second row of masonry

He graduated first row of masonry blocks in which it was necessary to set the maximum level and the horizontal one line. A straight line is achieved taut rope from one extreme to the other of the fence post (as a reference) and also served as the horizon.

When laying somewhere had to be added to the bottom seam between the block and the concrete ribbon longer solution. But the maximum - 1 cm. The tape is filled with sufficient accuracy. happy with the result, a start.

Further I decided to put between the layers of reinforcement blocks. Teh.resheniyah in the construction of houses of aerated concrete - always reinforced with the first layer. To make stock flexural strength (when frost heaving).

The grooves in my block is not propylene grinder - Expose the void. Rebar placed on top:

Who will fly again stones in my garden, what is the use of fiberglass reinforcement there. I wrote about this in a separate article - can express their opinions there.

Let me just say that the valve is working locally. If it is covered in concrete or mortar, its operating segment - is the length of the coil to the coil (or the length of the "wave" on the steel surface).

instagram viewer

So all sorts of arguments that it stretches, bends and does not work - do not find convincing arguments. it stretches and bends, by fixing only the extreme ends of the valve.

Diameter fittings - 6mm.

Yes, it plays during installation. But I screwed it to the posts and the bars made of ties binding wire - to fix the width between the two rods.

I moved and set up the pillars patterned blocks.

Stacked first five blocks of the second layer - on one side of the gate.

So it looks like close up. Photo on the smart phone in bright light gives the grays. Brown shade stones texture fades blocks.

Inlaid block column to the extreme where the pipe has been concreted, shifted with an error of 10 cm. But as you can see - we found a solution: full block with increased voiding.

Typesetting six blocks in the masonry on the other side spans. Next, I proceeded to the masonry wall blocks. Working with grouting and washing the (not beer - water) is slower than simply laying the blocks individually.

View of the sun. When they are covered with primer or varnish with giving the effect of "wet stone" surface - it will be more beautiful. In the wet it is clearly apparent.

There will be two layers of building blocks and covers. Above - fencing from the treated planks.

Grown grass - you need to mow the next week. But time is sorely lacking.

On the second day of the two output filled cavity inside composing concrete blocks.

Not flooded to the top. So that the next pouring spliced ​​with the lower blocks as a tongue and groove (for strength). At a void volume of 1.5 unit in average took floor concrete buckets.

I had not enough time to finish a third passage. It was necessary to move on to cleaning the day before flooded the next block party. These operation takes about 3 hours (20 units plus minor forms as lids).

Next article: Simple balusters manufacturing technology for stairs in garage conditions

Subscribe per channel, introducing it in the browser bookmarks. There is a lot of useful information and interesting articles.