Greenhouse as a workshop for casting concrete products decorative

Instead of building a makeshift shelter or as outbuildings, I decided to overpay a little bit and buy a normal greenhouse on galvanized metal frame and polycarbonate. If it later is not required, it can always start to use for its intended purpose. I bought:

- Summer Resident Toeplitz galvanized pipe 30x20 size 3h4m - 8 thousand.

- Polycarbonate Dionysus 4mm: 3 sheets - 6 th. rub.

I purchased in advance at the beginning of May. Included was the only frame fasteners. Acquiring the washer (which would not vomit polycarbonate), and is screwed on polycarbonate roofing screws, which remained on the installation of profiled sheet fence.

I moved all at once in the cabin of the car. I was surprised that everything was included. However, I think that the polycarbonate have to be fixed on the trunk and drive 40 km / h.

Assembled frame. Gathered case. First spaced and mounted wooden frame 3h4m 50h50mm of the bars (part was larch). I put it on the bricks and stones, that they would not touch the ground. On the inside of the carcass reinforcement hammered segments - approximately 0,5-0,7m. And pulled him through the frame slightly bent metal corner. The result windscreen - to the greenhouse is not overturned. Inside put scraps of old linoleum, which lay in the garage of a relative.

Next assembled frame greenhouses. Nothing complicated, all you can do the same one day.

The next day began to sheathe polycarbonate. The morning was a good sunny weather, but with the wind. Neighbor helped hold the sheets. Otherwise, the wind had lifted them and I'm alone in this weather could not fasten them. Another poveshat even a small castle - Utility room is always closed in my absence. Yes, nominal protection, but it is made from onlookers, who can go to the site.

Greenhouse Workshop with two entrances. Can be in the process of work is always open for ventilation. Advantages of this solution, which transpired during the operation:

- work within comfortable in any weather. The solar - to open the door. In rainy - all tightly;

- drenched afternoon concrete products are both in an autoclave. In the greenhouse air temperature and humidity in the sun rises to 10-20 degrees higher than outside. And at this temperature faster concrete sets and gaining greater strength.

- aesthetic appearance. Many people think that this is really my greenhouse. I asked why I did not put in a suitable place for it.

Held electric cable from the pole and mounted lighting and sockets inside the greenhouse. Lighting separately included inside and outside (above the door). When leaving, I disconnect the electricity in the brush - Workshop de-energized. Now you can work inside even when the darkness outside. This solution is allowed to increase working hours in the evening.

Later brother brought home-made vibration table (folding), who collected a couple of years ago. I wanted at the time to pour paving in the village on a small home. Little by little preparatory work progressed, and soon it was possible to proceed to the process of casting slabs of permanent formwork for the foundation.

Read more: Laying of communications under the base-plate

***

Subscribe per channel, introducing it in the browser bookmarks. There is a lot of useful information and interesting stories.