How to wash the tiles on the adhesive after repair?

The answer is obvious - with the help of a cleaner, just as it is to choose the right ?!

If you have used cement glue, then you clean it you can use the funds from the inhibited acids and cleaning agents.
⠀
Then carefully! Acid-based cleaners can ruin the natural stone (marble, granite), which if is not the foundation of your tiles, it can occur in decorative boxes.
⠀
Therefore, it is not necessary to apply funds immediately on the wall / floor, it is best limited to a small area. And this applies to all cleaning agents!

Once clean the entire surface, wash it with an alkaline solution or a neutral detergent.

If you are using an epoxy adhesive, do not hesitate to buy cleaners alkaline-based.

To remove fresh spots and stains, dilute the detergent with water, and if you suddenly decided to remove impurities 3-year-old - need heavy artillery undiluted.

Apply the product with a sponge, review all of my storiz and thoroughly rinse the surface. Yes, without storiz it does not work!
⠀
If the problem is in the grout, then keep reading - now tell all

The cement composition can be washed off with water, but with epoxy grout will have to suffer.

Do not grab the knife and do not try to scrape off dried residues - only scratch the tiles! You can use any solvents or float steam cleaner, but it is better to not kosyachit

If you are soiled tile paint and putty, the "keep the cams" that it was a water-emulsion composition.

This is easily removed with water or common cleaning agents, even if very badly.
⠀
It's all! Have anything to add - write in the comments, your advice, proven by experience, will definitely be useful and will save more than one bathroom.