Laying wiring in PVC pipe

Mounting of the corrugated pipe

Corrugated pipe are typically used in residential utility rooms (such as an attic), since the tube has an aesthetic appearance. Most often, the corrugated pipe used for wiring to the electrical panel to the apartments. For private homes corrugated pipe used as a protection of cables and wires going on overhead line to the house. However, there are a variant with a colored ribbed, be suitable for mounting in indoor wiring.

A small field wiring diagram in the corrugated pipe

Starting the installation corrugations considered drawing-drawing scheme. Remember pipe can not cross each other. Firstly, it is not aesthetically pleasing, and secondly contradicts safety requirements. Therefore, first carefully draw a diagram of the entire layout of the future tube wiring, eliminating the crossing with each other. After the drawing is made, we proceed to the purchase of the entire material and accessories necessary quantity corrugated pipe. We start to do the layout.

corrugated pipe of a certain diameter to properly, to take all of this the number of wires that must be undertaken within the pipe and check for pieces of pipe so that they all climbed. The void must be at least half the internal volume of the corrugated pipe, otherwise the wires will broach difficult or impossible.

As thread the wiring in the corrugated pipe

The corrugations are of a probe without it. If there are small patches can be applied corrugation without probe. If the length of the wire to be threaded through the corrugation, very long, you need to corrugation with wire probe.

How does the broaching wire.

end of the cable tie to the end of the wire probe, tightly clasped the hand tube. The other end of the wire is pulled through the wire corrugation. Several cables need to bind at the same time, the pipe pulling to right. Is marking and marked points for drilling holes for fastening sleeve. Often, the open method of laying a corrugated plastic pipe clips are used which are fixed to the ceiling and walls of the via-plug nails, screws.

When corrugated pipe diameter of 16 mm fasteners located at a distance of 30-40 cm. Corrugation 32 diameter, 40 mm requires a clip arrangement to the distance of 20-30 cm from each other. Then, all drilled holes in them is thrust a plastic dowels and screws are screwed which press clips. Next corrugation with the wires inserted into the clip. To disconnect the corrugations, simply pull the tube itself.

There are variations of fixing with metal staples and clamp catyagivayuschegosya. If the appearance of the pipe does not matter, you can use the tightening clamp, as this option is useful if you need to make installation fast. One clamp securing dowel-nail, a screw may connect several corrugations spanning clamp.

Metallorukav in the living room is not used, are located only in the technical areas. Metal hose is mainly used for laying data cables (internet, tv cable). metal hose thus performs the function of the screen of the external electromagnetic radiation pipe necessarily grounded.

PVC pipe mounted in the same way as corrugated. They are used in the auxiliary and non-residential premises where the wiring requires additional mechanical protection. Clips or other type of fastening may be positioned less than in the case of the corrugated tube, as well keep the PVC pipe size and do not bend.

The order of stacking the wiring in PVC pipe

Step 1. Is marking the walls with the help of the beating - dyed yarns.

Step 2. Mounting and installation raspayachnyh boxes.

Step 3. There have been a place of fastening clips for future pipe laying.

Step 4. Setting the clip.

Step 5. The pipes are cut into several pieces to length, and then to strengthen them in the clips and fit the dimensions of accessories.

Step 6. Wire extends through the tube and are finally set.

Share with us your ways of fixing the corrugated and PVC pipe.

Share this article with your friends on social networks !!!