Veranda Polycarbonate Attached Garage

Many have a country house (dacha), or your own private home for permanent residence. Today will tell, how to attach the verandah to the house of polycarbonate, To create a comfortable sitting area. Typically, a veranda built right along with the house on the same foundation. But you can attach it from polycarbonate.

The material is very strong and durable. Another plus - easy to work with. Small weight polycarbonate will perform their own installation. It is possible to make the veranda oval, round, square, and so arched. D.

To prevent fault polycarbonate, which may occur with changes in temperature, it is necessary to make holes for the fixing is not a lot more. It is important not to tighten the fittings strongly dense.

There is an outdoor type of construction and closed. Outdoor is used as a summer playground. Highlights - stand on which is mounted the roof. It is necessary to make a wall.

Closed type veranda is more like a full room. Private option can be used in any weather.

Construction of polycarbonate verandas will cost several times cheaper than any other material. Typically, the thickness of polycarbonate used is not higher than 1 cm.

Stages of construction verandas

Make a layout under the veranda. The next step - the foundation (enough to fill a tape with the reinforcing cage). You can make a pier foundation of bricks or pipes.

Pulled the trench. Its minimum width of 30 cm., And a depth of 40 cm. Create plywood or formwork planks.

After 14 - 30 days solidify the foundation and can be taken for designing the floor. Use a piece of ordinary board on top of the joists insulation. After the construction of the porch floor is covered with varnish or paint.

Along the perimeter of the base plate construct. Wooden boards (thickness 150x150 or 100x100 mm.) Is necessary to impregnate the refractory compositions. For the carcass can use metal pipes. Attach a metal pipe which is between by means of bolts, without welding.

Make vertical racks, fixing them with metal corners to trim. Tying often made of beams the size of 12x12 or 10x10 cm. Details of the chassis between a fixed brackets or screws.

When the frame is ready, it is possible to start mounting polycarbonate. Material can be cut to size using a hacksaw or jigsaw. Use rubber gaskets and screws with washers for fastening. After the wall will be erected, to proceed to the roof.

Roof is the best embodiment of the single-slope. The roof, too can be made of polycarbonate.

channel RemontDom He wants comfort and good mood for the whole day! Please Like - thank you for your attention.