Useful content

Miracle drill: tiles, glass and granite in one fell swoop

click fraud protection
Samples of materials for the experiment.
Samples of materials for the experiment.

This time, let's see how and how to drill a hole in glass, ceramic tiles, porcelain stoneware, granite, concrete, brick, in the wall, etc. I took three materials. I even got a piece of granite (if they didn't lie) from the cladding of the building store. Even if it is not granite, it is definitely porcelain stoneware. I will try to make a hole in all samples with the same drill with a carbide tip. Will it work?

S&R brand drill with a diameter of 6 mm and a length of 100 mm.
S&R brand drill with a diameter of 6 mm and a length of 100 mm.
The seller at a specialized point, a grandmother of about 70 years old, said that the drill is universal and will take everything, even metal. In this, of course, I did not believe, but since gave 220 rubles for him, I expected that porcelain stoneware should be mastered.

I was the first to decide to drill the glass, because here you need the freshest eye and a steady hand. I took a piece of a glass bottle, applied a cross and tried to hit it. I aimed at the mark on the neck and although it is round, it turned out to be done without problems (see. video). Drilled with a drill, wetting glass and drill bit along the way. About

instagram viewer
after 3 minutes the hole was ready.

The hole is ready.

Further in line was ceramic tile, which, I confess, was very surprised. I also drew a target with a marker and forward. I thought that the drill would crawl a little on the front gloss, but it immediately sank into the desired point and passed through the tile, as if through oil, in 10 seconds!!! You can see for yourself by watching the video. So the ceramic for this drill is dust.

Hole in a tile with a perfect edge on the face.

As expected, the hardest was a piece of granite (or porcelain stoneware) tiles, 10-11 mm thick. Under the onslaught of a sharp tip, he held out as much 3.5 minutes and was passed through! And this with pauses for wetting and cooling the drill. As with ceramics, the outer edges of the inlet are straight.

Granite tiles. The finished hole is just class!

At the end I turned over the tiles and granite and looked at the vents. They also pleasantly surprised with their quality and convinced that the drill coped with the task perfectly in all three cases. So what is it German drill from the brand S&R - thing worthwhile and convincing. After work, I did not notice any changes in the shape of the tip.

Outlets. Excellent result too

Write what you think about the quality of work and share your experience in drilling hard materials.

Feel free to evaluate the material andsubscribeper channel.

Mixer: what parts can be left when replacing
This is a fan! Only blade 66 m
Another "grasshopper": how practical is a bread clasp
I thought: markup is the key to good editing. But fixing it turned out to be even more difficult. How did I get out with the frame?

I thought: markup is the key to good editing. But fixing it turned out to be even more difficult. How did I get out with the frame?

Work in my house under construction continues, and at the same time the installation of the frame...

Read More

For flower beds and tire fences will now be fined: an innovation of 2021

For flower beds and tire fences will now be fined: an innovation of 2021

Once upon a time, back in Soviet times, there was a fashion for decorative fences and flower beds...

Read More

Carrot varieties that have almost no Disadvantages, which are praised by all the familiar Summer residents

I am an experienced gardener. And my flowers are luxurious, and there are always a lot of berries...

Read More

Instagram story viewer