Drain from drain pipes: cheap and fast

To preserve and protect the facade, the foundation will help drain systems. It is not necessary to spend a lot of money on ready-made system. You can save money and do everything much easier and cheaper by using sewer pipes.

Drain will last a long time, if the right to pick up the pipe. White is not recommended to use pipe. The plastic does not withstand cold weather and temperature drop. Gray pipes designed for high temperature, but do not like the severe frosts and heavy loads. Therefore it is necessary to constantly monitor and clean them from snow and ice.

There are brown and sewers. They are great for drainage. Brown pipe excellent tolerate high loads frosts.

One tube can be 2 the trough. Required plastic mounting brackets. They need to be placed every 60 cm. Abuse can be made of pipes for sewer by 110 mm. Vertical pipes for draining water from the pipes 50 mm.

Sewer pipes are not offended by the sun to drain, if you make a strong attachment (see how to do that later).

Make a homemade drain on the roof

Cut the pipe in half. Take 2 and the screw is screwed in the beginning and at the end of the pipe. We stretch the thread to mark the cutting line after the marker. Anchoring the tube from below by screws to the bar.

Sawn tube grinder the mark. Sawed one side of the tube, unscrew the screws. Overturn rezom down pipe. Fasten with screws to the bar. Again twirl screws on both sides to stretch the string and mark the place of the cut marker. Sawn grinder on the mark. Get 2 of the gutter.

Connect tube can screws at three locations (along the edges and in the middle). Pipe clamps can be bought ready-made gutter. They have clips that securely hold the edge of the pipe.

You can make holders and with their own hands. In this case, you will need a metal strip. Bend the strip of metal pipe. The metal must make a hole for fastening with screws pipes.

Bracket for drain must be inserted under the lower wave slate. Metal tightly enters the slate and did not even need to raise. The insert holders harvested along the length of the roof gutter.

It remains only to fix the screws from the bottom of the gutter. A pair of screws per mount and so on all holders. Now the tube will hold fast.

channel RemontDom thanks for your attention, sign, place Like.