Installation errors, cutting the choice of screws when dealing with plasterboard

gypsum plasterboard - material, which can not even professional work. Among the masters - the most popular decoration material, which helps to align the ceiling, walls, partitions to make, and so on.. But even experienced craftsmen make mistakes when dealing with plasterboard.

At work should follow which side mount moisture resistant drywall. Obverse possesses moisture resistant properties, does not get wet the surface strongly. Characterized the front side of high strength and quality of paper.

Screws

Incorrect depth screws. In order not to damage the material, do not screw the screws too deeply. Poor and otherwise, when the screw is not dokruchivaetsya. The proper depth of the screw in the drywall - 1 mm.

There are special tips to stop to tighten the screws to the correct depth. Step between the screws along the edges 10 - 15 cm. Central material - 20 - 24 cm.

Tightening the screws in gypsum board is too close to the edge of the fabric. The resulting material can crumble. It would be right to retreat from the edge of 10 - 15 mm.

Installation of sheet material Extension - it correctly and protect against cracking. In the photo you can see below a mistake: Poor quality plating of small parts in a row.

Not properly chosen thickness of the plasterboard for the construction of partition walls. For use galvanized frame profile (75 mm). Frame sheathe sheets GCR screws. Thickness 12.5 mm plasterboard.

Do I need to putty plasterboard

There are reasons why it is important to putty plasterboard. If you plan to paint, it is necessary to putty plasterboard. Drywall is actually not perfectly smooth. If you plan to finish embossed wallpaper, putty is not necessarily.

Another thing, when used for the finishing of thin wallpaper. Wallpaper will show through and be visible location putty where screws and between the sheets of plasterboard.

A thin layer of a polymeric filler is advised experienced craftsman go anyway. This is necessary if you want to change the wallpaper in the future, so as not to damage the front side gispokartona.

How to cut drywall

Cutting gipsokartna to make a clean cut, use a regular knife stationery. To hold the knife on line and break mark sheet slice. Edge will be perfectly smooth.

It is not necessary to install drywall close to the floor. Make a gap between the sheet and the floor, as the material absorbs moisture and can expand.

Screws with a press washer

When collecting the frame profile, is often used screw with a press washer "bug". Compound really durable, but when mounting the sheets on the GCR profile plasterboard is loosely fitted to the profile.

Exit - Prosekatel used for the metal profile. As a result, there will be nothing to stick out and the connection will be reliable and durable.

These are the basic mistakes that are often made to work with plasterboard. channel RemontDom He wishes a successful repair, thanks for the Huskies and subscription.