Useful content

Our pool with a pavilion. Everything worked out

click fraud protection

Plinth finishing, operation, costs

Spring is approaching, and then summer is at hand, it's time to think about suburban leisure. For those who cannot imagine their site without a swimming pool, FORUMHOUSE has prepared another story in the first-person publication cycle. In the family Jazzmeen inflatable the pool appeared before the house and while the construction was in progress, "roamed" around the yard. Finally, hands reached him.

Jazzmeen

Participant FORUMHOUSE

My story is about building a swimming pool with a pavilion.

Plinth finish

They decided to sheathe the plinth with siding.

A door was made on the rear wall of the base for easy access to the equipment. Hatches were also made in the flooring for the same purpose.

When installing the equipment under the flooring, naturally, a chlorine generator was also connected. To our volume of water, 50 kg (2 bags of 25 kg) of tableted salt were added. And that was enough for the rest of the season. We didn't expect this. We thought that we would have to add it several times. We bought 10 bags (250 kg), with an expectation for the future. If this continues, then this salt will last for 10 years... In general, we'll see. The final appearance of the pavilion.

instagram viewer

The most expensive part, of course, is the pavilion. But despite this, in general, this entire project cost us less than 500 thousand.

Swimming pool operation

The deck was covered with Neomid terrace oil. For two (and in some places three) layers, a 2 liter can was enough. Chosen transparent, as long as the wood has its natural color. When it gets dark, we will cover it in the color of a nut, or something else. It’s only the first year, it’s not getting dark. The pool is not connected to the sewerage system. At the end of the season, we drain the water by a third, to the nozzles, and top up in the spring. Top up during the season, as it evaporates, and also, after washing the filter.

This is what the pavilion and pool look like now.

A bubble wrap was placed on the surface of the water to reduce water evaporation.

This summer, of course, they did not open the doors full. And swimming with the doors closed is okay. But if you also wanted to sit there, then you had to move it a little, since the temperature reached over 40 degrees. We also just used these doors as entrance doors. In general, I do not regret that they are.

Snow leaves the roof almost immediately, it does not linger. Between the pavilion and the fence about 1.5 meters. This winter is not an indicator, of course: there is very little snow. Let's see what will happen next.
This is how it looks now.

The bottom line of an indoor pool, of course, has many advantages: the water in the pool is significantly warmer, and the air around it is also. This is very important for our climate.
Last year, even without the pavilion, in the spring the ice in the pool melted for a very long time, only in the 20th of April it melted. This year there is now only a layer of ice of about 1 cm. Winter, of course, is warm, but in a pond, for example, 10 centimeters of ice, we chopped an ice hole on weekends.
Also, last year after winter there was a lot of dirt in the pool, we were tortured to vacuum. And throughout the season a lot of debris comes in. Now the water is clear and clear. And in the summer, already with the pavilion, there were much fewer problems with garbage.

The swimming season was closed at the end of October, when frosts came, we dismantled the equipment, drained some of the water, and laid a film on the surface of the water. Until that time, we swam after the steam room.
Then, in November, the temperature increased and we could have jumped some more, but we didn't open the pool again.

Today is a very sunny day. At noon, the temperature in the pavilion was already 18 degrees. Now, probably already more.

Support the story, like it!

How we build a pool with a pavilion:

  1. Preparation
  2. Mounting the bowl
  3. Selection of a pavilion, installation of a ramp
  4. Assembly of the pavilion
  5. Pavilion cladding, interior decoration
  6. Our pool with a pavilion. Everything worked out

Subscribe to the channel, we have prepared a lot of interesting and useful publications. Make a repost in your social networks, for sure, some of your friends will find this experience useful! Join the FORUMHOUSE!

And how do you think the voiced amenities are worth such costs?

How to use the remains of wooden planks and bars. 6 useful ways to use them

How to use the remains of wooden planks and bars. 6 useful ways to use them

Hurrah! The repair is over! But what about the leftover material? Throw away?! It's a shame. And ...

Read More

Created "electronic skin" that can stretch and enlarge 28 times

Created "electronic skin" that can stretch and enlarge 28 times

The new electronic skin was developed by the engineering group of the King Abdullah University of...

Read More

Cut, without waiting for peritonitis!

Cut, without waiting for peritonitis!

Spring works in the garden begin with pruning fruit trees. In March, when there is snow, trees ri...

Read More

Instagram story viewer