Rainwater harvesting is a great way to use natural resources for the benefit of your yard. This will not only save time and money for paying utility bills, but will also make life outside the city more comfortable.
The collection system will prevent the accumulation of water and provide additional liquid that can be useful for watering the beds. In addition, garden plants absorb such water much better.
Read also Autumn: what care does the roof of the house need
Working principle of rainwater harvesting
The principle of communicating vessels operates in the water collection system:
the collector collects water and delivers it to the tank (accumulator), to which it is connected by a piece of hose;
when the water level in the tank rises to its maximum, the water goes into the drain or into the sewer, going down the sewer.
Water assembly installation
Designing and installing a water collection system is a relatively simple process. The following guide will help you figure this out:
Choosing the right place. The most important thing is accessibility and convenience. Therefore, it is desirable to place the system on the drainpipe of a dwelling or garage or in a utility room. However, you can resort to another option - to bury the rainwater collection system in the ground near the house. In this case, the degree of soil freezing and the location of groundwater should be taken into account.
Markup. After choosing a suitable place, you need to correctly mark the surface of the pipe. It is necessary to measure the height of the barrel and determine the location of the water collector. When it comes to the design of the collector, you should first choose a suitable height, and then the location.
Site preparation. At this stage, you will need a grinder or any other tool for working with metal products, such as a hacksaw. Using one of the tools, you need to cut off the intended section of the pipe. In this vacant place, the collector is fixed.
Installation of a water collector. The two parts of the collector are connected: the top of the collector is attached to the upper cut of the pipe. Accordingly, its bottom is planted on the lower cut. The structure is now ready to connect the tank.
Connection of parts of the system. Make a small hole in the top of the tank. And with the help of a cut off piece of hose, connect it to the water collector. If desired, a coarse filter can be installed inside the pipe. It will rid the water of excess debris. The filter must be stainless steel. You can buy it in the form of baskets or lattices.
Read also How to install a gutter on the roof of a house
Thus, with the help of such a collection system, an additional source of water is acquired, and life in a country house becomes more pleasant and convenient. The main thing is to remember that from time to time you need to look after the system and change the filter in time, if any. This will extend the life of the structure and save additional time and effort.