How to make a flat angle on the ceiling moldings without special tools by hand.

Ceiling moldings can not only make decorating aesthetic appearance, but also perfectly conceals uneven boundary between the ceiling and the wall.

The process of installation is very simple and can easily be made with your own hands. Difficulties often arise only in cutting corners. Usually corners on ceiling moldings cut with a special device Miter.

But what if it is not?

Hurry to buy miter box is not necessary. Equal angle can be done by hand and without special tools. How? Consider the following.

The layout for cutting the inner corner of ceiling moldings will make the ceiling using a conventional pencil.

To do this, apply a baseboard corner abutting it against the wall. With a pencil draw the line along the baseboard directly on the ceiling.

Then, putting a plinth on the opposite side and just draw the line with a pencil.

As a result, the ceiling got two lines that intersect. It is at the intersection and will have to converge plank ceiling moldings.

This is the highest point of the future cut.

Now you need to move the marks on the ceiling moldings.

To do this, again putting a ceiling moldings to the corner and using a pencil mark on the outer edge of its upper cut-off point. On the domestic - to make notes directly in a corner.

The same action is carried out on the opposite side.

After marking applied to the ceiling moldings, proceed to the cutting angle using stationery knife.

Ceiling skirting put on a hard surface, and focusing on the mark, cut.

Trimmed baseboards are putting into the corner for the quality control section. If you notice uneven interface, adjust them using a knife, after which you can proceed to further installation.

And so, without the use of special tools can make even the angle of the hands.