The most popular ways washed down the door frame with his hands.

I washed down the door frame - it is one of the most important steps of the installation of interior doors. It largely affects how much will look aesthetically pleasing door after installation. It is therefore necessary to make a correct and washed down nicely.

There are two most popular ways washed down the door frame, which is quite possible to make their own hands. What kind? Consider the following.

The first method is the simplest and can be made with your own hands, with those special skills are needed.

it washed down at 90 degrees.

Will produce work on a flat surface (the best place on the floor). Strap on the door frame of the future plot the layout.

For road marking do shallow washed down by a miter saw to remove unnecessary parts of the porch.

Just washed down can be done not only by means of miter saw, but also with a hacksaw with a fine tooth.

Then, using a hammer and chisel to gently remove the unnecessary end portion of the vestibule. Cut, to ensure good connections, alignment.

Elements collect on the floor of the box and connect the ends by means of two screws on each side.

The second method requires the presence of already cross-cut saws and skills to work with her. Mainly this method is used for the elements of the door frame with a circular cross section.

it washed down with an angle of 45 degrees.

On the frame miter saw set alternately strips next door frame with applied markings and gashes are made at an angle of 45 degrees.

Just washed down at an angle of 45 degrees can be done with the help of a carpenter's miter box. But all the same trim, a much better and faster.

In conclusion, I want to say that it is easier with their hands washed down the door frame at an angle of 90 degrees. Buy miter saw for the installation of several door not appropriate.