How to install beacons to align the walls with his own hands.

To achieve a perfectly flat wall surfaces in alignment without beacons almost impossible. Even builders with extensive experience in line the walls with them, because to correct irregularities after plaster beacons without complicated and long.

In fact, the installation of beacons technology is quite simple. If you know the characteristics of the process and observe the correct installation sequence, it is possible to put beacons on their own, without the help of professionals. How correctly to install beacons with their hands? Consider the following.

The installation process begins with the preparation of beacons walls. They must be cleaned of dust and sand with a brush and primed.

Then the wall, starting from the corner, divided by vertical lines, which will set the beacons. Spacing is usually chosen in size rules, but not more than one and a half meters. This is necessary in order to further it easier to plaster.

To install beacons to knead rotgips state plastic and sticky masses on wall and causes small flip flops with a spatula at a distance of 25-30 cm.

Is then applied to spanked beacon (guide profile) and slightly recessed with his fingers at each of points in rotgipsa solution.

Using laser level and a polygon aligned on the vertical of the beacon.

Just align the lighthouse, you can use the rules and spirit level.

Having the correct position of the lighthouse surplus rotgipsa remove with spatula. On both sides of the lighthouse form a smooth slopes.

After drying slaps beacon remaining unfilled portions about the entire vertical fill rotgipsa solution and form neat slopes.

The installation process is completed the lighthouse. According to this principle established lighthouses on the perimeter.