Useful content

How to use a halogen lamp elements vypayat SMD

click fraud protection

So, we are all gathered here in varying degrees, hams and dig deeper into the burned-out devices (boards) - it familiar and, as they say, everyday. After all, there can be found a whole bunch of useful and most important working parts, it remains only to remove them from there.

And it is good if you have a complete set of all necessary accessories such as: Rework Station, Desoldering, set of needles, infrared soldering, etc. And what if all of the tools have only a soldering iron and direct hands? Going out there and being quite simple - it's automotive halogen lamp.

why lamp

So, there is quite a logical question, which is light and how can it help? And here's the thing: in the automotive lamp as the light source is a tungsten filament, which is in the process of their work is not only emits visible light, but also a huge amount of infrared radiation that we just will use.

We do not even have to use a new bulb, old enough to take two strand, which was a whole one spiral (low or high beam).

instagram viewer
Note. If you do not have these, ask a neighbor, burned out and do not mind to give.

preparation of materials

So, in addition to the automotive lamp must also prepare the tweezers, gloves, stationery knife, foil, scissors, a source (battery or regulated power supply) and to start an unnecessary cost to experiment and stuff hand.

Preparing bulbs

So, the first step is to prepare the lamp. To do this, carefully wipe the lamp bulb. It must be completely clean from any kind of dirt and grease. It is also necessary to connect the wires with the conclusions of the lamp and the insulated terminals with insulation tape or shrink tubing.

Important. Do not forget to prepare a good sunglasses, for the light will shine at full capacity and will dazzle you when you control the watering process.

Getting watering details

So, take charge and choose the item that will desoldering. Now, in order not to expose to unnecessary heating of adjacent components, take the foil and scissors and close neighboring elements.

Thereafter we don gloves (as during lamp operation becomes very hot) piece camouflage foil lamp as follows (in order not to dazzle the eye) and begin to warm up near the solder details.

As soon as the solder is melted, using tweezers simply remove the item.

So now let's try to remove the item from the computer motherboard.

It took a little longer, but vypayat still happen.

The process of preparing and watering can see in this video.

Attention. Once you vypayat detail and cut off power to the lamp, do not touch it with bare hands, as it has for some time it will be very hot. Its operating temperature of the lamp reaches 600 degrees Celsius.

conclusion

That is so uncomplicated and maximum budget is possible desoldering parts of boards (resistance, LEDs, capacitors), which you can then use in their electronic artefacts. Like this, then vote it Like. Thank you for your attention!

4 options for a delicious hedge in the country: we grow thorny walls from berries (kiwi in Siberia)

4 options for a delicious hedge in the country: we grow thorny walls from berries (kiwi in Siberia)

In the country or in a private house, many people choose not a solid, solid fence, but a hedge. I...

Read More

Such a planting of Garlic in the fall guarantees a rich harvest in any winter.

Like many gardeners, I prefer winter varieties of garlic. At first I just planted it, but then I ...

Read More

Made a reconstruction of the pantry. Eh, now I'll live!

Made a reconstruction of the pantry. Eh, now I'll live!

Photo 1. This is what the room looked like before the renovation began.I think not many apartment...

Read More

Instagram story viewer