Vetrovlagozaschita and steam frame house

Vetrovlagozatsschita and steam - are two sides of the same pie. Parozilyatsiya protects the insulation from inside the building, and the windscreen - from the outside.

Vapor barrier

This additional protection is designed to prevent the steam from the space inside the heater. The vapor barrier can be used as the special film and polyethylene.

In the process of human activity inevitably generates steam, which moves from a warm room into a cold area - on the street, including through walls. Quality and reliable vapor barrier designed to prevent the ingress of vapor from inside the house insulation.

Mistakes when installing vapor barriers can lead to very unpleasant consequences. Impregnated into structure pairs will accumulate in developing wicking which, cumulatively, begins impair the consumer properties of insulating materials, and also leads to rotting of wooden elements frame.

Of course, absolutely airtight construction is not possible, but as much as possible to protect the building from the excess moisture as possible.

Vetrovlagozaschita

Wind protection is designed for a wide range of tasks:

- protection of the building from the wind.
- Protect the building from atmospheric moisture.
- Additional thermal protection.
- ensuring unhindered through heater exit steam from the inside of the building.

Windproof film - is a material that has both diffuse and breathability properties. This film is called diffusion membrane.

Vetrovlagozaschita as an important element of the frame of the building, as well as paroizilyatsiya, and neglect it not worth it, otherwise you expose the building to additional risk of infection by fungus and mold.

When mounting layer, which protects the building from atmospheric influence, you need to follow some rules.

Diffuse film - element exterior trim, so it is desirable to install it in dry weather. To begin the installation of the film should be only when it is laid insulation material, but has not yet started finishing walls.

Before starting work, you must decide which side it is necessary to strengthen the film to the wall. Fleecy side of it is placed in the side of the building. The smooth side facing outward. On the outside, the smooth side of the film coated logos of the manufacturer. This is done in order not to make mistakes and to properly install the material.

Vetrovlagozaschitu decompose very desirable and horizontally mounted from bottom to top so that each succeeding sheet overlaps the first about 10-15 cm. Thus, the accumulated moisture will roll down wind moisture protection, without falling into the insulation or rough finishing walls.

The film can be cut out with scissors or a knife stationery. Before cutting, leave a considerable allowance, at least 10 centimeters, to provide installation lap next piece.

Under no circumstances should there be sagging and blistering of the film, since it is facing at installation can cause damage to the windshield.

Fastened film plastic dowels rate of 5 pieces per square meter. You can use a staple gun.

In the next article we will talk about the main types of exterior finish frame house.