Even experienced master does not know all these tricks when working with a drill
In this article I will tell (and show graphically) some tricks when working with a drill. Let's start with the most simple and well-known, and in the end you will see the advice that often surprises even experienced craftsmen in its simplicity.
So if your back is already a lot of years of experience in construction, then immediately look into the end of the publication;)
For clarity, the article uses footage from the video channels TNOMER and Home master
How to squeeze a little bit into the chuck?
Sometimes it is necessary to drill a small hole with a thin drill, but here it is clamped in the drill chuck is not obtained. Then come to help ordinary adhesive tape, which must be neatly wound on the drill ground. Also, you can use the sandpaper, thin wire or a piece of rubber.
How to get rid of debris during drilling?
The easiest way is a common plastic bottle. Or rather its lower part, you want to cut and drill a hole in the middle of the desired diameter. Especially good use of such a case when the drill is something high above him and shavings flying in the face.
How not to drill too deep?
Often we need to make the hole a predetermined depth, the drill bit is not got out from a neighbor in the apartment. This will help us again duct tape - are putting to drill dowel and wound a piece of tape on the drill size plugs with a small margin. Now we will be able to quickly make holes required depth.
How to drill a rubber or carpet?
Not often, but still sometimes we need to make a hole in the rubber, carpet or thick fabric. But the usual drill can not be used because it could easily just break stuff. Instead, we find a piece of the desired diameter of the tube, sharpen edges and use for drilling.
How can sharpen up the phone?
This can be done quite simply - we fix a piece of pipe in the drill and sharpen on sandpaper or a grindstone. The process is quite fast and the power of even a person who holds a drill for the second time in his life.
How to make a precise through-hole?
For this purpose, we need to list the most usual of paper and a marker. Winding a sheet of paper in a single layer around the pipe and make a mark on the paper sheet is then folded in half to this mark and the second mark do fold. It only remains to again wind the paper tube and transfer the data to mark and drill pipe.