I put the first metal sheets. Nuances and mistakes without them, has not done any stage of my building.

Again, another, new to me, the case. And so it seems and everything is easy to simply not yet started ...

Finally, all the preparations are made and everything is thought out to the smallest detail (I thought 😎) before the last important step in this construction season.

Here is an interesting article about the stages of my training:

Fixing kontrobreshetki. 🔨Vazhnye points that not everyone pays attention.

Fixing the membrane to the roof alone. Simple things together that facilitated my work.

Counter-sealing tape under. How I made the replacement of expensive materials?

Under the metal crate. Valuable tips that I have tried myself.

Simple things you can not miss. My revision before installing the metal.

How to avoid damaging the metal roofing? I am doing the right ladder for the installation of the roof.

It's time to close all the metal tile.

✅ As always starring me and my other half, who throughout the building helps me where alone does not do anything.

🔹 begins the ascent.

It would seem a small piece of 2 by 1 meter, but how uncomfortable it was to climb to the roof with them. With one hand holding it, and the other on the ladder. In this case, you need to throw the legs up to the roof, and to keep my assistant there, too, with all these coping ...

But here I was a little happyI did not buy a larger size sheets. I can not imagine how it would all rose.

As a result, tormented with a few sheets, I built something like a rail, of two boards that are placed along the stairs. According to him, it is much more convenient to drag everything up.

🔹 The first sheet, the first jamb.

It seems that everything has been counted many times, but I still feared that the waves of sheets can not get to the crate.

❗ These disturbances were in vainAll coincided, "as in a drugstore." I got another school.

In the article, where I described cove installation strap, I mentioned that I made one mistake, which then gave me a lot of trouble. And it manifested itself.

Cornice strip I put myself in a corner battens and slides down a little, that there was a gap between it and the ventilation grid. And now the lower edge of metal, not hanging from the strap, and got up on her last wave, lifting the top.

And how do you think I became remodel ???Nea ... How could I then remembered and regretted it. But about it to tell apart ...

✅ And at that moment, it seemed to me that there is nothing wrong, and visually, this "take-off" sheet at the lower end, is not evident.

🔹 All smoothly, can be attached.

Well, sort of leveled the first sheet from the top secured the second, then lower again. It seems to be all around the edges evenly (about). Put third topsheet and a few below, I will not leave ...

❗Well, you could fix them permanently!Do not ever do... Always better to expose the end of all "on two self-tapping screws", and then finally to mount.

Only then, I realized that all the "apparent evenness" in the end may change. I got out to the middle of it.

Gone not lower edgeAt which I attended, and the topTo which I did not pay attention.

The reason I did not know what to do with it, too... A day came to an end.

That's what was my first experience in the installation of metal. And as you know, it is a special joy to me not prines.😐

But what I do is corrected, continue to "gain experience", read the following articles.

put huskies 👍 and 💥SUBSCRIBE TO CHANNEL💥, not to miss the fun.