The gap between the wall and mauerlat. How to prevent the occurrence of such a problem?

Cracks in the house should not be - it's true. But sometimes these problems are far-fetched ...

Even in a stone house, you can face the problem of cracks in the tree. How can it be to tell today.

My construction is moving forward, and I am now working on a ceiling.

But today the issue is associated with mauerlat, which of course is already set.

✅ Doubts I have appeared before its installation, and they are connected with the density of the boards fit to one another and to the wall.

I thought about it when came across one video where mauerlat was, like me, of the two boards 150 to 50, and among them was laid mezhventsovogo insulation. This was done just to remove the gap between the boards.

❗ On the one hand it is logicalBut I did not enclose anything, and here's why.

Held tightly.

My mauerlat attached to the wall studs at approximately every meter.

• Between the wall and waterproofing paved mauerlat that under good crimping serves also as a sealant.
• As well as between the boards, under normal crackdown, blowing through exactly should not be. Of course it may be that the entire plane full board do not touch each other. But it is not necessary for the following reason.
  instagram viewer

Insulation of the outside.

This is what needs to be done, even if it is not to be warmed the whole house.

Even if mauerlat be pillared, 150 mm thickness is enough for normal energy.

For this mauerlat I arranged with a space from the outer edge of the wall is 100 mm. This distance is just enough to put outside 100 mm of insulation.

• It will reduce heat loss.
• And take away the possible blowing.

So everything is solved simply and unnecessary troubles here are not necessary.

A kraynyak can all blow foam 😁.

💥Subscribe to KANAL💥 and put the Huskies 👍. In comments write, if faced with such a problem.